47-32-17: Landing Gear Inspection Covers
FAA order 47-32-17 is an airworthiness directive. The FAA's subject line: Landing Gear Inspection Covers. It names Bellanca 14: about 282 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: landing gear.
What it applies to as the FAA lists it
- Kind of product
- Aircraft
- Makes
- Bellanca Aircraft Corporation
- Models
- 14-13, 14-13-2
- On this site
- Bellanca 14 282 registered
Dates and paperwork
- Docket
- Unknown
- Status
- Current
- The FAA's document
- Read the order on the FAA's site
The order itself the regulatory text, as published
Show the full text (851 characters)
47-32-17 BELLANCA: (Was Mandatory Note 7 of AD-773-5.) Applies to Models 14- 13, 14-13-2 Serial Numbers 1060, and Up.
Compliance required prior to October 15, 1947.
Improper positioning of the inspection covers on the top surface of each wing at the landing gear retracting sprocket can cause malfunctioning of the gear retracting mechanism. This cover is held in place by two spring clips, and if the cover is installed with the clips running in a chordwise direction, it is possible that the ends of the clips will bear against the chain and force it off the sprocket, jamming the system. Inspect the covers on your airplane for proper installation, and paint arrows on the cover and wing surface so that the arrows point toward each other when the spring clips run spanwise.
(Bellanca Service Bulletin No. 10 covers this same subject.)
Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/47-32-17.json · aircraft systems.