2017-01-02: Flight Control Systems

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2017-01-02 The Boeing Company: Amendment 39-18769; Docket No. FAA- 2016-7419; Directorate Identifier 2015-NM-189-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective February 21, 2017. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to The Boeing Company Model 787-8 and 787-9 airplanes, certificated in any category, as identified in Boeing Alert Service Bulletin B787-81205-SB270032-00, Issue 001, dated November 3, 2015. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 27, Flight Control Systems. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by a report that some inboard and outboard trailing edge flap rotary actuators may have been assembled with an incorrect no-back brake rotor-stator stack sequence during manufacturing. We are issuing this AD to detect and replace rotary actuators having incorrect assembly, which could cause accelerated unit wear that will eventually reduce braking performance. This degradation could lead to loss of no-back brake function and reduced controllability of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Inspection and Other Actions \n\n\n\tWithin 60 months after the effective date of this AD, do an inspection of the inboard and outboard trailing edge flap rotary actuator for any discrepant rotary actuator, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin B787- 81205-SB270032-00, Issue 001, dated November 3, 2015. If any discrepant rotary actuator is found, within 60 months after the effective date of this AD, do the actions specified in paragraph (g)(1) or (g)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin B787-81205-SB270032- 00, Issue 001, dated November 3, 2015. \n\t(1) Replace the discrepant rotary actuator. \n\t(2) Check the maintenance records to determine the flight cycles of each discrepant rotary actuator and, within 60 months after the effective date of this AD, do all applicable related investigative and corrective actions. \n\n(h) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it tothe attention of the person identified in paragraph (i) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\t(4) For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (h)(4)(i) and (h)(4)(ii) of this AD apply. \n\t(i)The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. If a step or substep is labeled ''RC Exempt,'' then the RC requirement is removed from that step or substep. An AMOC is required for any deviations to RC steps, including substeps and identified figures. \n\t(ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition. \n\n(i) Related Information \n\n\n\tFor more information about this AD, contact Fnu Winarto, Aerospace Engineer, Systems and Equipment Branch, ANM-130S, FAA, Seattle ACO, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6659; fax: 425-917-6590; email: [email protected]. \n\n(j) Material Incorporated byReference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Alert Service Bulletin B787-81205-SB270032-00, Issue 001, dated November 3, 2015. \n\t(ii) Reserved. \n\t(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740- 5600; telephone 562-797-1717; Internet https://www.myboeingfleet.com. \n\n((Page 4778)) \n\n\n\t(4) You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425 227-1221. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.