The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2013-23-06: Fuel

FAA order 2013-23-06 is an airworthiness directive in force since December 30, 2013. The FAA's subject line: Fuel. It names Boeing 757: about 440 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: fuel system.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
757-200 Series, 757-200PF Series
On this site
Boeing 757 440 registered

Dates and paperwork

In force since
December 30, 2013
Published
November 25, 2013 (signed November 6, 2013)
Docket
FAA-2013-0693
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 757-200 and -200PF series airplanes. This AD was prompted by reports indicating that a standard access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. This AD requires an inspection of the left- and right-hand wing fuel tank access doors to determine that impact-resistant access doors are installed in the correct locations, and to replace any door with an impact-resistant access door if necessary. This AD also requires an inspection for stencils and index markers on impact-resistant access doors, and application of new stencils or index markers if necessary. This AD also requires revising the maintenance program to incorporate changes to the airworthiness limitations section. We are issuing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes or engine exhaust nozzle), consequently leading to a fuel-fed fire.

The order itself the regulatory text, as published

Show the full text (6,501 characters)
Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2013-23-06 The Boeing Company: Amendment 39-17661; Docket No. FAA- 2013-0693; Directorate Identifier 2013-NM-059-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective December 30, 2013. \n\n((Page 70198)) \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to The Boeing Company Model 757-200 and -200PF series airplanes; certificated in any category; as identified in Boeing Service Bulletin 757-28-0118, dated January 12, 2012. \n\n(d) Subject \n\n\n\tJoint Aircraft System Component (JASC)/Air Transport Association (ATA) of AmericaCode 28, Fuel. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by reports indicating that a standard access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. We are issuing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes or engine exhaust nozzle), consequently leading to a fuel-fed fire. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Inspections \n\n\n\tWithin 72 months after the effective date of this AD, do the actions specified in paragraphs (g)(1) and (g)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 757-28-0118, dated January 12, 2012. \n\t(1) Do a general visual inspection of the left- and right-hand wing fuel tank access doors to determine whether impact-resistant access doors are installed inthe correct locations. If any standard access door is found, before further flight, replace with an impact- resistant access door, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 757-28-0118, dated January 12, 2012. \n\t(2) Do a general visual inspection of the left- and right-hand wing fuel tank impact-resistant access doors to verify stencils and index markers are applied. If a stencil or index marker is missing, before further flight, apply stencil or index marker, as applicable, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 757-28-0118, dated January 12, 2012. \n\n(h) Maintenance Program Revision \n\n\n\tWithin 60 days after the effective date of this AD, revise the maintenance program to incorporate critical design configuration control limitations (CDCCLs) Task 57-AWL-01, ''Impact-Resistant Fuel Tank Access Doors,'' of Section 9, Airworthiness Limitations (AWLs) and Certification Requirements (CMRs) of Boeing 757 Maintenance Planning Data Document D622N001-9, Revision August 2012. \n\n(i) No Alternative Actions, Intervals, and/or CDCCLs \n\n\n\tAfter accomplishing the revision required by paragraph (h) of this AD, no alternative actions (e.g., inspections), intervals, and/ or CDCCLs may be used unless the actions, intervals, and/or CDCCLs are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j) of this AD. \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Suzanne Lucier, Aerospace Engineer, Propulsion Branch, ANM-140S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6438; fax: 425-917-6590; email: [email protected]. \n\n(l) MaterialIncorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Service Bulletin 757-28-0118, dated January 12, 2012. \n\t(ii) Critical design configuration control limitation (CDCCL) Task 57-AWL-01, ''Impact-Resistant Fuel Tank Access Doors,'' of Section 9, Airworthiness Limitations (AWLs) and Certification Requirements (CMRs) of Boeing 757 Maintenance Planning Data Document D622N001-9, Revision August 2012. \n\t(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544- 5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. \n\t(4) You may view this service information at FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Related safety bulletins advice on the same designs, not orders

2026-04-062026-09 · HYDRAULIC POWER, Hydraulic Power Transfer Unit System
2025-02-212025-02 · DOORS, Main Deck Cargo Door
2025-01-142025-01 · HYDRAULIC POWER SYSTEM, Fatigue Failure of Hydraulic Flexible Hoses
2020-04-16NM-20-07 · Navigation - Glideslope System
2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/2013-23-06.json · aircraft systems.