Show the full text (4,799 characters)
2000-22-17 SOCATA - GROUPE AEROSPATIALE: Amendment 39-11964; Docket No. 2000 CE-34-AD.
(a) What airplanes are affected by this AD? This AD affects the following airplane models, all serial numbers, certificated in any category:
MS 880B
MS 885
MS 892A-150
MS 892E-150
MS 893A
MS 893E
MS 894A
MS 894E
Rallye 100S
Rallye 150T
Rallye 150ST
Rallye 235C
Rallye 235E
(b) Who must comply with this AD? Anyone who wishes to operate any of the above airplanes must comply with this AD.
(c) What problem does this AD address? The actions specified by this AD are intended to correct rudder clevis and elevator control clevis that are too thin because of abnormal wear, and the consequent failure of the rudder and elevator clevis. Such failure could lead to loss of directional or pitch control.
(d) What actions must I accomplish to address this problem? To address this problem, you must accomplish the following actions:
Actions
Compliance TimesProcedures
(1) Inspect the elevator and rudder control clevis for abnormal wear. Measure clevis thickness. The thickness at the bent section should be at least 0.043 inch (in)/1.1 millimeter (mm).
Within the next 100 hours time-in-service (TIS) after December 29, 2000 (the effective date of this AD), and thereafter at intervals not to exceed 600 hours TIS.
Do this inspection in accordance with the ACCOMPLISHMENT INSTRUCTIONS of Socata Mandatory Service Bulletin SB 155-27, dated April 2000.
(2) If, during inspection, the elevator or rudder control clevis measures a thickness less than 0.043 in/1.1 mm, replace the clevis.
Before further flight after the inspection where abnormal wear was found.
Do this action in accordance with the ACCOMPLISHMENT INSTRUCTIONS of Socata Mandatory Service Bulletin SB 155-27, dated April 2000.
(3) Lubricate the clevis.
Within the next 100 hours TIS after December 29, 2000 (the effective date of this AD), and thereafter at intervals not toexceed 100 hours TIS.
Do this action in accordance with the ACCOMPLISHMENT INSTRUCTIONS of Socata Mandatory Service Bulletin SB 155-27, dated April 2000.
(e) Can I comply with this AD in any other way? You may use an alternative method of compliance or adjust the compliance time if:
(1) Your alternative method of compliance provides an equivalent level of safety; and
(2) The Manager, Small Airplane Directorate, approves your alternative. Submit your request through an FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Small Airplane Directorate.
Note 1: This AD applies to each airplane identified in paragraph (a) of this AD, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (e) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if you have not eliminated the unsafe condition, specific actions you propose to address it.
(f) Where can I get information about any already-approved alternative methods of compliance? You can contact Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64016; telephone: (816) 329-4146; facsimile: (816) 329-4090.
(g) What if I need to fly the airplane to another location to comply with this AD? The FAA can issue a special flight permit under sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate your airplane to a location where you can accomplish the requirements of this AD.
(h) Are any service bulletins incorporated into this AD by reference? Actions required by this AD must be done in accordance with Socata Mandatory Service Bulletin SB 155-27, dated April, 2000. The Director of the Federal Register approved this incorporation by reference under 5 U.S.C. 552(a) and 1 CFR part 51. You can get copies from SOCATA Groupe AEROSPATIALE, Customer Support, Aerodrome Tarbes-Ossun-Lourdes, BP 930 - F65009 Tarbes Cedex, France; telephone: (33) (0)5.62.41.73.00. You can look at copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.
(i) When does this amendment become effective? This amendment becomes effective on December 29, 2000.
Note 2: The subject of this AD is addressed in French AD number 2000-174(A), dated May 3, 2000.
