Bell 407 accident near Big Lake, Texas, December 29, 2012

The NTSB's narrative final · quoted from the NTSB record

The pilot reported that, while in cruise flight, the helicopter suddenly yawed 10 degrees right. He was able to control the yaw and subsequently heard an alarm and observed an rpm warning light. After silencing the alarm, he noticed a 2- to 3-percent decrease in rpm for the engine and rotor. As the pilot began to scan the flight controls and instruments, he saw the "check instrument segment" illuminate, and the measured gas temperature gauge begin to flash and display a reading of "E 920." The pilot stated that all of the other engine indications were in the normal operating ranges. During the precautionary landing, when the helicopter was about 10 to 15 ft above ground level and 20 knots, the engine "quit." The pilot responded by moving the throttle to idle and increasing the collective pitch. The helicopter subsequently hit the ground hard, which resulted in substantial damage to the tailboom. During the postaccident examination of the engine, three fractures were found in the outer combustion case at the fuel nozzle port. Two of the three fractures originated at the intersection of the circumferential weld that joined the reinforcing ring to the main skin and exhibited heat tinting consistent with the cracks having been open during engine operation. The third fracture ran adjacent to the reinforcing ring to the main skin interface. All three fractures exhibited signatures consistent with high-cycle fatigue. The investigation determined that the operator was not conducting the manufacturer-recommended postflight and scheduled maintenance inspections of the outer combustion case; these cracks would likely have been detected during such inspections.

The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.