The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

85-16-06: Fuel Flowmeter Tube Assembly

FAA order 85-16-06 is an airworthiness directive in force since September 6, 1985. The FAA's subject line: Fuel Flowmeter Tube Assembly. It names Airbus A300, Mcdonnell Douglas DC-10: about 137 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: other and general.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Airbus; The Boeing Company
Models
A300 B2-1A, A300 B2-1C, A300 B2-203, A300 B2K-3C, A300 B4-103, A300 B4-203, A300 B4-2C, DC-10-15, DC-10-30, DC-10-30F (KC-10A, KDC-10)
On this site
Airbus A300 120 registered
Mcdonnell Douglas DC-10 17 registered

Dates and paperwork

In force since
September 6, 1985
Docket
Unknown
Status
Current
The FAA's document
Read the order on the FAA's site

The order itself the regulatory text, as published

Show the full text (2,297 characters)
85-16-06 MCDONNELL DOUGLAS AND AIRBUS INDUSTRIE: Amendment 39-5112. Applies to McDonnell Douglas Model DC-10-15, -30, and KC-10A (Military) series airplanes, and CF6-50C powered Airbus Industrie Model A-300 series airplanes. Compliance is required as indicated.\n\n\tTo prevent failure of the fuel flowmeter tube assembly, accomplish the following, unless already accomplished:\n\n\tA.\tWithin the next 1000 flight hours after the effective date of this AD, inspect the fuel flowmeter tube assemblies in accordance with McDonnell Douglas Alert Service Bulletin A73-20, dated January 7, 1985, or later revisions approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region; or Airbus Industrie Service Bulletin A300-73-007 (associated with modification 5912), as appropriate. Perform the inspection every 1000 flight hours until paragraph B., below, is accomplished. If any cracks are found, accomplish the requirements of paragraph B. before any further revenue flight.\n\n\tB.\tWithin one year after the effective date of this AD, install the fuel flowmeter tube assembly P/N-ASLO538-503 in accordance with McDonnell Douglas DC-10 Alert Service Bulletin A73-20, dated January 7, 1985, or later revisions approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region.\n\n\tC.\tSpecial flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD.\n\n\tD.\tAlternate means of compliance which provide an acceptable level of safety may be used when approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region.\n\n\tAll persons affected by this directive who have not already received these documents from the manufacturer may obtain copies upon request to the McDonnell Douglas Corporation, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Director, Publications and Training, C1-750(54-60). These documents also may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or Los Angeles Aircraft Certification Office, 4344 Donald Douglas Drive, Long Beach, California.\n\n\tThis amendment becomes effective September 6, 1985.

Related safety bulletins advice on the same designs, not orders

2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565
2014-11-24NM-15-03 · Flight Controls
2008-12-11NM-09-03 · Engine Fuel and Control - Implementing Fuel Tank System Airworthiness Limitations
2008-07-02NM-08-31 · Equipment/Furnishings: Non-Textile Floors
2006-12-11SW-07-13 · Oxygen Reserve Cylinder

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/85-16-06.json · aircraft systems.