47-41-08: Stabilizer Bar Mixing Levers
FAA order 47-41-08 is an airworthiness directive. The FAA's subject line: Stabilizer Bar Mixing Levers. It names Bell 47: about 478 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: other and general.
What it applies to as the FAA lists it
- Kind of product
- Aircraft
- Makes
- Scotts-Bell 47 Inc
- Models
- 47B, 47B3
- On this site
- Bell 47 478 registered
Dates and paperwork
- Docket
- Unknown
- Status
- Current
- The FAA's document
- Read the order on the FAA's site
The order itself the regulatory text, as published
Show the full text (790 characters)
47-41-08 BELL: (Was Mandatory Note 20 of AD-1H-2.) Applies to All Models of 47B Series, Through Serial Number 78.
Compliance required at next 100-hour inspection.
The stabilizer bar mixing levers should be reworked by cutting away the lower inboard edge of a 2-inch radius from a center position 1 1/2 inches from the vertical centerline of the center hole. The cut should not be more than 1/8 inch at its deepest point and the sharp corners, resulting from the removal of this segment, should be rounded by a 1/2-inch radius. This reworking will eliminate the interference between those levers and the stabilizer bar damper, which may exist when the stabilizer bar is depressed 5 degrees.
(Complete instructions are carried by Bell Service Bulletin 47C52, dated July 9, 1947.)
Related safety bulletins advice on the same designs, not orders
2001-02-09SW-01-13 ·
Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/47-41-08.json · aircraft systems.