47-10-19: Cabin Heater Fuel Solenoid Valve
FAA order 47-10-19 is an airworthiness directive. The FAA's subject line: Cabin Heater Fuel Solenoid Valve. System: engine.
What it applies to as the FAA lists it
- Kind of product
- Aircraft
- Makes
- Lockheed Aircraft Corporation
- Models
- 49-46
Dates and paperwork
- Docket
- Unknown
- Status
- Current
- The FAA's document
- Read the order on the FAA's site
The order itself the regulatory text, as published
Show the full text (1,022 characters)
47-10-19 LOCKHEED: (Was Mandatory Note 21 of AD-763-3.) Applies to All Model 49 Serials Up to and Including 2088, Except as Noted.
Compliance required not later than 100 hours of operation after June 10, 1947.
(a) In each cabin heater installation, relocate and waterproof the fuel solenoid valve and replace and reroute the fuel pump bypass line.
(LAC Service Bulletin 49/SB-73 covers this same subject.)
(b) In zone 2 of each nacelle, install heat protective shield between propeller feathering line and cowl diaphragm. Applies to all serials up to and including 2082.
(LAC Service Bulletin 49/SB-150 covers this same subject.)
(c) In each outboard nacelle main junction box, replace existing mounting nuts (tinnerman) and PK screws with AN 366 nuts and NAS 221 screws.
(LAC Service Bulletin 49/SB-152 covers this same subject.)
(d) Drill one 1/4-inch drain hole on lower center line of spinner fairing lower panel assembly for each engine.
(LAC Service Instruction 49/SI-95 covers this same subject.)
Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/47-10-19.json · aircraft systems.