Show the full text (4,769 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2026-07-02 Dassault Aviation: Amendment 39-23297; Docket No. FAA-2025-2553; Project Identifier MCAI-2025-00186-T. (a) Effective Date This airworthiness directive (AD) is effective May 11, 2026. (b) Affected ADs None. (c) Applicability This AD applies to Dassault Aviation Model FALCON 2000EX airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2025-0042, dated February 19, 2025 (EASA AD 2025-0042). (d) Subject Air Transport Association (ATA) of America Code 24, Electrical power. (e) Unsafe Condition This AD was prompted by a report of simultaneous failures of the main DC buses powered by Generator 1 (GEN1), and Generator 2 (GEN2) after flap extension during approach, which initially resulted in intermittent display of crew alerting system (CAS) messages, and led to the loss of the main DC buses. The FAA is issuing this AD to address intermittent and flickering data, as well as CAS messages. The unsafe condition, if not addressed, could lead to increased pilot workload, possibly during a critical phase of flight. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2025-0042. (h) Exceptions to EASA AD 2025-0042 (1) Where paragraph (1) of EASA AD 2025-0042 specifies to "inform all flight crews and, thereafter, operate the airplane accordingly," this AD does not require those actions as those actions are already required by existing FAA operating regulations (see 14 CFR 91.9 and 91.505 and 14 CFR 121.137). (2) Where EASA AD 2025-0042 refers to its effective date, this AD requires using the effective date of this AD. (3) This AD does not adopt the "Remarks" section of EASA AD 2025-0042. (i) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD and email to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Additional Information For more information about this AD, contact Steven Dzierzynski, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7367; email: 9-AVS-AIR-BACO-COS@faa.gov. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2025-0042, dated February 19, 2025. (ii) [Reserved] (3) For EASA material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov. Issued on March 25, 2026. Steven W. Thompson, Acting Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2026-06627 Filed 4-3-26; 8:45 am]BILLING CODE 4910-13-P