Show the full text (4,474 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2023-23-13 Rolls-Royce Deutschland Ltd & Co KG: Amendment 39-22615; Docket No. FAA-2023-1888; Project Identifier MCAI-2023-00298-E. (a) Effective Date This airworthiness directive (AD) is effective January 4, 2024. (b) Affected ADs None. (c) Applicability This AD applies to Rolls-Royce Deutschland Ltd & Co KG (RRD) Model RB211-Trent 875-17, RB211-Trent 877-17, RB211-Trent 884-17, RB211-Trent 884B-17, RB211-Trent 892-17, RB211-Trent 892B-17, and RB211-Trent 895-17 engines. (d) Subject Joint Aircraft System Component (JASC) Code 7230, Turbine Engine Compressor Section. (e) Unsafe Condition This AD was prompted by reports of cracks on the intermediate-pressure compressor (IPC) rotor shaft balance land. The FAA is issuing this AD to detect cracks on the IPC rotor shaft balance land. The unsafe condition, if not addressed, could lead to IPC rotor shaft failure and consequent uncontained high-energy debris, resulting in damage to the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Except as specified in paragraphs (h) and (i) of this AD: Perform all required actions within the compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2023-0040, dated February 16, 2023 (EASA AD 2023-0040). (h) Exceptions to EASA AD 2023-0040 (1) Where EASA AD 2023-0040 refers to its effective date, this AD requires using the effective date of this AD. (2) This AD does not adopt the Remarks paragraph of EASA AD 2023-0040. (3) Where the service information referenced in EASA AD 2023-0040 specifies to use certain tooling, equivalent tooling may be used. (i) No Reporting Requirement Although the service information referenced in EASA AD 2023-0040 specifies to notify the manufacturer or supply pictures to the manufacturer of any cracks, dents, or nicks, this AD does not include that requirement. (j) Alternative Methods of Compliance (AMOCs) (1) The Manager, AIR-520 Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the branch, send it to the attention of the person identified in paragraph (k) of this AD and email to: ANE-AD-AMOC@faa.gov. (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (k) Additional Information For more information about this AD, contact Sungmo Cho, Aviation Safety Engineer, FAA, 2200 South 216th Street, Des Moines, WA 98198; phone: (781) 238-7241; email: sungmo.d.cho@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2023-0040, dated February 16, 2023. (ii) [Reserved] (3) For service information identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; phone: +49 221 8999 000; email: ADs@easa.europa.eu; website: easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu. (4) You may view this service information at FAA, Airworthiness Products Section, Operational Safety Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call (817) 222-5110. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov. Issued on November 20, 2023. Ross Landes, Deputy Director for Regulatory Operations, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-26302 Filed 11-29-23; 8:45 am]BILLING CODE 4910-13-P