2023-17-02: Flight controls

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2023-17-02 Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics): Amendment 39-22528; Docket No. FAA-2023-1215; Project Identifier MCAI-2023-00196-T. (a) Effective Date This airworthiness directive (AD) is effective October 19, 2023. (b) Affected ADs None. (c) Applicability This AD applies to Saab AB, Support and Services (formerly known as Saab AB, Saab Aeronautics) Model 340A (SAAB/SF340A) and SAAB 340B airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2022-0216R1, dated February 1, 2023; corrected February 2, 2023 (EASA AD 2022-0216R1). (d) Subject Air Transport Association (ATA) of America Code 27, Flight controls. (e) Unsafe Condition This AD was prompted by reports of a high number of events related to stall warnings upon landing, following introduction of the ice speed function within the stall warning system. The FAA is issuing this AD to address a margin to stall warning that is lower when ice speed is ON than with ice speed OFF. The unsafe condition, if not addressed, could lead to inappropriate stall warnings during the landing phase and result in increased pilot workload during a critical phase of flight. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2022-0216R1. (h) Exceptions to EASA AD 2022-0216R1 (1) Where EASA AD 2022-0216R1 refers to November 16, 2022 (the effective date of EASA AD 2022-0216), this AD requires using the effective date of this AD. (2) The "Remarks" section of EASA AD 2022-0216R1 does not apply to this AD. (i) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Saab AB, Support and Services' EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Additional Information For more information about this AD, contact Shahram Daneshmandi, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 206-231-3220; email Shahram.Daneshmandi@faa.gov. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2022-0216R1, dated February 1, 2023; corrected February 2, 2023. (ii) [Reserved] (3) For EASA AD 2022-0216R1, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; website easa.europa.eu. You may find this EASA AD on the EASA website at ad.easa.europa.eu. (4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fr.inspection@nara.gov, or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on August 17, 2023. Victor Wicklund, Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-19899 Filed 9-13-23; 8:45 am]BILLING CODE 4910-13-P