Show the full text (4,845 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by: a. Removing Airworthiness Directive 2023-01-12, Amendment 39-22306 (88 FR 3629, January 20, 2023); and b. Adding the following new airworthiness directive: 2023-13-14 Safran Helicopter Engines, S.A. (Type Certificate Previously Held by Turbomeca, S.A.): Amendment 39-22499; Docket No. FAA-2023-1411; Project Identifier MCAI-2023-00710-E. (a) Effective Date This airworthiness directive (AD) is effective July 25, 2023. (b) Affected ADs This AD replaces AD 2023-01-12, Amendment 39-22306 (88 FR 3629, January 20, 2023) (AD 2023-01-12). (c) Applicability This AD applies to all Safran Helicopter Engines, S.A. (Type Certificate previously held by Turbomeca, S.A.) Model Arriel 1C, Arriel 1C1, Arriel 1C2, and Arriel 1K1 engines. (d) Subject Joint Aircraft System Component (JASC) Code 7200, Engine (Turbine/Turboprop). (e) Unsafe Condition This AD was prompted by false engine fire warnings. The FAA is issuing this AD to prevent false engine fire warnings. The unsafe condition, if not addressed, could lead to commanded in-flight engine shut-down, possibly resulting in damage to the helicopter and reduced control of the helicopter. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Except as specified in paragraphs (h) and (i) of this AD: Perform all required actions within the compliance times specified in, and in accordance with European Union Aviation Safety Agency (EASA) AD 2023-0110, dated May 26, 2023. (h) Exceptions to EASA AD 2023-0110 (1) Where the "Reference Date" for Model Arriel 1K1 engines in Table 1 of EASA AD 2023-0110 specifies "The effective date of this [EASA] AD," this AD requires using the effective date of this AD. (2) Where the "Reference Date" for Model Arriel 1C, Arriel 1C1, and Arriel 1C2 engines in Table 1 of EASA AD 2023-0110 specifies "02 January 2023," this AD requires compliance before further flight. (3) This AD does not adopt the Remarks paragraph of EASA AD 2023-0110. (4) Although the service information referenced in EASA AD 2023-0110 specifies to discard any removed fire detectors, this AD requires removing those parts from service. (i) No Reporting Requirement Although the service information referenced in EASA AD 2023-0110 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (j) Alternative Methods of Compliance (AMOCs) (1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (k) of this AD and email to: ANE-AD-AMOC@faa.gov. (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (k) Additional Information For more information about this AD, contact Kevin Clark, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (781) 238-7088; email: kevin.m.clark@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) European Union Aviation Safety Agency AD 2023-0110, dated May 26, 2023. (ii) [Reserved] (3) For EASA AD 2023-0110, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; phone: +49 221 8999 000; email: ADs@easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu. (4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call (817) 222-5110. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email: fr.inspection@nara.gov, or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on June 30, 2023. Michael Linegang, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-14585 Filed 7-6-23; 11:15 am]BILLING CODE 4910-13-P