2021-13-03: Fuel Control/Turbine Engines

The Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-13-03 Safran Helicopter Engines, S.A. (Type Certificate previously held by Turbomeca, S.A.): Amendment 39-21608; Docket No. FAA-2020-1180; Project Identifier MCAI-2020-00517-E. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) is effective August 13, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to Safran Helicopter Engines, S.A. (Type Certificate previously held by Turbomeca, S.A.) Arriel 2B, 2B1, 2C, 2C1, 2C2, 2S1 and 2S2 model turboshaft engines with a fuel filter pre-blockage pressure switch, part number 9 550 17 200 0, and serial number (S/N) 00001 to 12753, inclusive, and S/N A0001 to A0247, inclusive, installed. \n\n(d) Subject \n\n\n\tJoint Aircraft System Component (JASC) Code 7321, Fuel Control/ Turbine Engines. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by reports from the manufacturer of non- conforming fuel filter pre-blockage pressure switches manufactured before December 2016. The FAA is issuing this AD to prevent the non- conformity of the fuel filter pre-blockage pressure switch, which can cause its non-activation in case of fuel system contamination, with consequent opening of the by-pass without indication in the cockpit. The unsafe condition, if not addressed, could result in uncommanded in-flight shut-down of the engine, an emergency autorotation landing on a single engine helicopter, or an uncommanded in-flight shut-down of both engines on a twin engine helicopter. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Required Actions \n\n\n\t(1) After the effective date of this AD, during the pre-flight inspection for the first flight of each day the engine is operated, perform a visual inspection of the fuel filter by-pass indicator to determine if the fuel filter by-pass indicator pop-up has been activated. \n\t(2) Within the next 300 hydro-mechanical metering unit (HMU) operating hours or 180 days after the effective date of this AD, whichever occurs first, perform an operational test of the fuel filter pre-blockage pressure switch in accordance with Task 73-23- 01-750-801-A01--Pre-Blockage Pressure Switch of the Fuel Filter Tests (Electrical), dated November 30, 2012, (the Task) from the Turbomeca Arriel 2 S1 Maintenance Manual. \n\t(3) During any visual inspection required by paragraph (g)(1) of this AD, if the fuel filter by-pass indicator pop-up has been activated or, during the operational test required by paragraph (g)(2) of this AD, any discrepancy is detected as described by theTask, before next flight, replace the fuel filter pre-blockage pressure switch with a part eligible for installation. \n\t(4) The actions required by paragraph (g)(1) of this AD may be performed by the owner/operator (pilot) holding at least a private pilot certificate, and must be entered into the aircraft records showing compliance with this AD, in accordance with 14 CFR 43.9 (a)(1) through (4) and 14 CFR 91.417(a)(2)(v). The records must be maintained as required by 14 CFR 91.417, 121.380, or 135.439. \n\n(h) Terminating Action \n\n\n\tPassing the operational test (no failure detected) of the fuel filter pre-blockage pressure switch, as required by paragraph (g)(2) of this AD, or replacement of the fuel filter pre-blockage pressure switch with a part eligible for installation, constitutes a terminating action for the repetitive visual inspections required by paragraph (g)(1) of this AD for that engine. \n\n(i) Definition \n\n\n\tA part eligible for installation is a fuel filter pre-blockage pressure switch that is not listed in the Applicability, paragraph (c), of this AD, or a fuel filter pre-blockage pressure switch that has passed the operational test (no discrepancies detected) required by paragraph (g)(2) of this AD. \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, ECO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ECO Branch, send it to the attention of the person identified in Related Information. You may email your request to: ANE-AD-AMOC@faa.gov. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\n(k) Related Information \n\n\n\t(1) For more information about this AD, contact Wego Wang, Aviation Safety Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803; phone: (781) 238-7134; fax: (781) 238-7199; email: wego.wang@faa.gov. \n\t(2) Refer to EASA AD 2019-0180, dated July 25, 2019, for more information. You may examine the EASA AD in the AD docket at https://www.regulations.gov by searching for and locating Docket No. FAA- 2020-1180. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Task 73-23-01-750-801-A01--Pre-Blockage Pressure Switch of the Fuel Filter Tests (Electrical), dated November 30, 2012, from the Turbomeca Arriel 2 S1 Maintenance Manual. \n\t(ii) (Reserved) \n\t(3) For Turbomeca service information identified in this AD, contact Safran Helicopter Engines, S.A., Avenue du 1er Mai, Tarnos, France; phone: +33 (0) 5 59 74 40 00. \n\t(4) You may view this service information at FAA, Airworthiness Products Section, Operational Safety Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call (781) 238-7759. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email: fedreg.legal@nara.gov, or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on July 1, 2021. Ross Landes, Deputy Director for Regulatory Operations, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-14520 Filed 7-8-21; 8:45 am) BILLING CODE 4910-13-P