2019-24-18: Navigation

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2019-24-18 The Boeing Company: Amendment 39-21007; Docket No. FAA- 2019-0252; Product Identifier 2019-NM-048-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective February 3, 2020. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to The Boeing Company airplanes, identified in paragraphs (c)(1) through (3) of this AD, certificated in any category. \n\t(1) Model 727, 727C, 727-100, 727-100C, 727-200, and 727-200F series airplanes, as identified in Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; except for airplanes having variable numbers QB065, QD191, QD192, QD402, QD403, QD407, and QD410. \n\t(2) Model 757-200, -200PF, -200CB, and -300 series airplanes, as identified in Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019. \n\n((Page 71782)) \n\n\n\t(3) Model 767-200, -300, -300F, and -400ER series airplanes, as identified in Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 34, Navigation. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by reports of nuisance stick shaker activation while the airplane accelerated to cruise speed at the top of climb. This AD was also prompted by an investigation of those reports that revealed that the angle of attack (AOA) (also known as angle of airflow) sensor vanes could not prevent the build-up of ice, causing the AOA sensor vanes to become immobilized, which resulted in nuisance stick shaker activation. The FAA is issuing this AD to address ice build-up in the AOA sensor faceplate and vane, which may immobilize the AOA sensor vanes, and could result in inaccurate or unreliable AOA sensor data being transmitted to airplane systems and consequent loss of controllability of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Required Actions \n\n\n\tExcept as specified in paragraph (h) of this AD: Within 36 months after the effective date of this AD or at the applicable times specified in paragraph 1.E., ''Compliance,'' of Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019; or Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018; as applicable, whichever occurs first, do all applicable actions identified as ''RC'' (required for compliance) in, and in accordance with, the Accomplishment Instructions of Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019; or Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018; as applicable. All replacements of the affected AOA sensors must be done before further flight. \n\n(h) Exceptions to Service Information Specifications \n\n\n\t(1) Where Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019; or Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018; as applicable, uses the phrase ''the original issue date of this service bulletin,'' this AD requires using ''the effective date of this AD.'' \n\t(2) Where Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019; or Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018; specify to accomplisha general visual inspection of the AOA sensors and to replace affected AOA sensors, a review of the airplane maintenance records is acceptable in lieu of those actions if the part number of the installed AOA sensors can be conclusively determined during that review to have a new or serviceable AOA sensor part number identified in Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019; Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019; or Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018; as applicable. \n\n(i) Credit for Previous Actions \n\n\n\tThis paragraph provides credit for actions specified in paragraph (g) of this AD, if those actions were performed before the effective date of this AD using Boeing Alert Service Bulletin 727- 34A0247, dated January 2, 2019. \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Los Angeles ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, Los Angeles ACO Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\t(4) For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (j)(4)(i) and (ii) of this AD apply. \n\t(i) The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. If a step or substep is labeled ''RC Exempt,'' then the RC requirement is removed from that step or substep. An AMOC is required for any deviations to RC steps, including substeps and identified figures. \n\t(ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Jeffrey W. Palmer, Aerospace Engineer, Systems and Equipment Section, FAA, Los Angeles ACO Branch, 3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 562-627-5351; fax: 562-627-5210; email: [email protected]. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Alert Service Bulletin 727-34A0247, Revision 1, dated October 1, 2019. \n\t(ii) Boeing Alert Service Bulletin 757-34A0611, Revision 1, dated March 22, 2019. \n\t(iii) Boeing Alert Service Bulletin 767-34A0828, dated December 6, 2018. \n\t(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740- 5600; telephone 562-797-1717; internet https://www.myboeingfleet.com. \n\t(4) You may view this service information at the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email [email protected], or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html.