2018-21-13: Landing Gear

Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by removing Airworthiness Directive (AD) 2018-11-05, Amendment 39-19293 (83 FR 24016, May 24, 2018), and adding the following new AD: 2018-21-13 Honda Aircraft Company LLC: Amendment 39-19471; Docket No. FAA-2018-0513; Product Identifier 2018-CE-013-AD. (a) Effective Date This AD is effective November 27, 2018. (b) Affected ADs This AD replaces AD 2018-11-05, Amendment 39-19293 (83 FR 24016, May 24, 2018) (``AD 2018-11-05''). (c) Applicability This AD applies to Honda Aircraft Company LLC (Honda) Model HA- 420 airplanes, all serial numbers, that: (1) Have power brake valve (PBV), part number (P/N) HJ1-13243- 101-005 or HJ1-13243-101-007, installed; and (2) are certificated in any category. (d) Subject Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 32, Landing Gear. (e) Unsafe Condition This AD was prompted by reports of unannunciated asymmetric braking during ground operations and landing deceleration. We are issuing this AD to detect failure of the PBV. The unsafe condition, if not addressed, could result in degraded braking performance and reduced directional control during ground operations and landing deceleration. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Insert Temporary Revision Into the Airplane Flight Manual (AFM) Before further flight after May 29, 2018 (the effective date retained from AD 2018-11-05) insert Honda Temporary Revision TR 01.1, dated February 16, 2018 (temporary revision), into the Honda HA-420 Airplane Flight Manual (AFM). The procedures listed in the temporary revision are required while operating with PBV P/N HJ1- 13243-101-005 or P/N HJ1-13243-101-007 installed. This insertion and the steps therein may be performed by the owner/operator (pilot) holding at least a private pilot certificate and must be entered into the airplane records showing compliance with this AD in accordance with 14 CFR 43.9 (a)(1) through (4) and 14 CFR 91.417(a)(2)(v). The record must be maintained as required by 14 CFR 91.417, 121.380, or 135.439. (h) Replace the Power Brake Valve As of and at any time after May 29, 2018 (the effective date retained from AD 2018-11-05), if any of the procedures listed in the temporary revision referenced in paragraph (g) of this AD reveal a leaking PBV, before further flight, replace the installed PBV, P/N HJ1-13243-101-005 or P/N HJ1-13243-101-007, with the improved PBV, P/N HJ1-13243-101-009. The replacement must be done using the Accomplishment Instructions in either Honda Service Bulletin SB-420- 32-001, dated January 8, 2018 (SB-420-32-001), or Honda Service Bulletin SB-420-32-001, Revision B, dated April 16, 2018 (SB-420-32- 001, Revision B). Before further flight after installing P/N HJ1- 13243-101-009, remove the temporary revision from the Honda HA-420 AFM. (i) No Reporting Requirement Although SB-420-32-001 and SB-420-32-001, Revision B specify submitting certain information to the manufacturer, this AD does not require that action. (j) Mandatory Replacement Within the next 12 months after November 27, 2018 (the effective date of this AD), if not previously done as a result of paragraph (h) of this AD, replace the installed PBV, P/N HJ1-13243-101-005 or P/N HJ1-13243-101-007, with the improved PBV, P/N HJ1-13243-101-009. The replacement must be done using the Accomplishment Instructions in either SB-420-32-001 or SB-420-32-001, Revision B. Before further flight after installing P/N HJ1-13243-101-009, remove the temporary revision from the Honda HA-420 AFM. (k) Special Flight Permit Special flight permits for the AFM Limitations portion of this AD are prohibited. Special flight permits for the PBV replacement required in this AD are permitted with the following limitations: One ferry flight, including fuel stops, to a service center with the temporary revision incorporated into the Honda HA-420 AFM. (l) Alternative Methods of Compliance (AMOCs) (1) The Manager, Atlanta ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (m) of this AD. [[Page 53371]] (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (3) For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (l)(3)(i) and (ii) of this AD apply. (i) The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. An AMOC is required for any deviations to RC steps, including substeps and identified figures. (ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition. (m) Related Information For more information about this AD, contact Samuel Kovitch, Aerospace Engineer, Atlanta ACO Branch, FAA, 1701 Columbia Avenue, College Park, Georgia 30337; phone: (404) 474-5570; fax: (404) 474- 5605; email: [email protected]. (n) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (3) The following service information was approved for IBR on April 13, 2018 (83 FR 13401, March 29, 2018). (i) Honda Aircraft Company Temporary Revision TR 01.1, dated February 16, 2018. (ii) Honda Aircraft Company Service Bulletin SB-420-32-001, dated January 8, 2018. (4) The following service information was approved for IBR on May 29, 2018 (83 FR 24016, May 24, 2018). (i) Honda Aircraft Company Service Bulletin SB-420-32-001, Revision B, dated April 16, 2018. (ii) [Reserved] (5) For Honda Aircraft Company LLC service information identified in this AD, contact Honda Aircraft Company LLC, 6430 Ballinger Road, Greensboro, North Carolina 27410; telephone (336) 662-0246; internet: http://www.hondajet.com. (6) You may view this service information at FAA, Policy and Innovation Division, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call 816-329-4148. In addition, you can access this service information on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-0513. (7) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.