The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2017-25-02: Placards and markings

FAA order 2017-25-02 is an airworthiness directive in force since December 21, 2017. The FAA's subject line: Placards and markings. System: other and general.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Fokker Services B.V.
Models
F.28 Mark 1000, F.28 Mark 2000, F.28 Mark 3000, F.28 Mark 4000

Dates and paperwork

In force since
December 21, 2017
Published
December 6, 2017 (signed November 22, 2017)
Docket
FAA-2017-1098
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are adopting a new airworthiness directive (AD) for certain Fokker Services B.V. Model F28 Mark 1000, 2000, 3000, and 4000 airplanes. This AD requires contacting the FAA to obtain instructions for addressing the unsafe condition on these products, and doing the actions specified in those instructions. This AD was prompted by reports indicating that certain exit signs have a hydrogen isotope that decays over time, causing the signs to lose their brightness. We are issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (3,604 characters)
Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): 2017-25-02 Fokker Services B.V.: Amendment 39-19116; Docket No. FAA- 2017-1098; Product Identifier 2012-NM-216-AD. (a) Effective Date This AD becomes effective December 21, 2017. (b) Affected ADs None. (c) Applicability This AD applies to Fokker Services B.V. Model F28 Mark 1000, 2000, 3000, and 4000 airplanes, certificated in any category, as specified in paragraphs (c)(1) and (c)(2) of this AD. (1) Serial numbers 11029, 11030, and 11042 in pre-SBF28/33-13 Appendix V configuration. (2) Serial numbers 11006, 11012, 11016, 11018, 11020, 11024, 11027, 11028, 11032 through 11038, 11043 through 11049, 11053, 11054, 11061 thru 11087, 11089 through 11113, 11115 through 11124, 11126 through 11132, 11134, 11136 through 11202, 11204 through 11224, 11226 through 11235, 11237, 11238, 11240, 11991, and 11992. [[Page 57541]] (d) Subject Air Transport Association (ATA) of America Code 11, Placards and markings. (e) Reason This AD was prompted by reports indicating that certain exit signs have a hydrogen isotope that decays over time, causing the signs to lose their brightness. We are issuing this AD to prevent insufficiently illuminated exit signs, which could possibly prevent safe evacuation during an emergency and cause injury to occupants. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Within 30 days after the effective date of this AD, request instructions from the Manager, International Section, Transport Standards Branch, FAA, to address the unsafe condition specified in paragraph (e) of this AD; and accomplish the actions at the times specified in, and in accordance with, those instructions. Guidance can be found in Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) AD 2012-0239, dated November 9, 2012. (h) Alternative Methods of Compliance (AMOCs) The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (i)(2) of this AD. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (i) Related Information (1) Refer to MCAI EASA AD 2012-0239, dated November 9, 2012, for related information. You may examine the MCAI on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-1098. (2) For more information about this AD, contact Tom Rodriguez, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1149. (j) Material Incorporated by Reference None.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/2017-25-02.json · aircraft systems.