2017-19-17: Ice and Rain Protection

Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by removing Airworthiness Directive (AD) 2016-17-02, Amendment 39-18615 (81 FR 55366, August 19, 2016), and adding the following new AD: 2017-19-17 Dassault Aviation: Amendment 39-19047; Docket No. FAA- 2017-0494; Product Identifier 2016-NM-126-AD. (a) Effective Date This AD is effective October 27, 2017. (b) Affected ADs This AD replaces AD 2016-17-02, Amendment 39-18615 (81 FR 55366, August 19, 2016) (``AD 2016-17-02''). (c) Applicability This AD applies to the Dassault Aviation airplanes identified in paragraphs (c)(1) and (c)(2) of this AD, certificated in any category. (1) Model FALCON 900EX airplanes, serial numbers (S/Ns) 270 through 291 inclusive and 294. (2) Model FALCON 2000EX airplanes, S/Ns 263 through 305 inclusive, 307 through 313 inclusive, 315, 320, and 701 through 734 inclusive. (d) Subject Air Transport Association (ATA) of America Code 30, Ice and Rain Protection. (e) Reason This AD was prompted by a design review of in-production airplanes that identified a deficiency in certain wing anti-ice system ducting. We are issuing this AD to detect and correct a deficiency in the wing anti-ice system ducting, which could result in reduced performance of the wing anti-ice system with potential ice accretion and ingestion, and could result in degraded engine power and degraded handling characteristics. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Retained Revision to the Airplane Flight Manual (AFM), With No Changes This paragraph restates the requirements of paragraph (g) of AD 2016-17-02, with no changes. (1) For Model FALCON 900EX airplanes on which the actions specified in Dassault Service Bulletin F900EX-464 have not been accomplished: Within 10 flight cycles after September 6, 2016 (the effective date of AD 2016-17-02), revise Section 4-200-05A, ``OPERATION IN ICING CONDITIONS,'' of the Model Falcon 900EX AFM to include the information in figure 1 to paragraph (g)(1) of this AD, and thereafter operate the airplane accordingly. The AFM revision may be done by inserting a copy of this AD into the AFM. BILLING CODE 4910-13-P [[Page 44307]] [GRAPHIC] [TIFF OMITTED] TR22SE17.000 (2) For Model FALCON 2000EX airplanes on which the actions specified in Dassault Service Bulletin F2000EX-393 have not been accomplished: Within 10 flight cycles after September 6, 2016 (the effective date of AD 2016-17-02), revise Section 4-200-05A, ``OPERATION IN ICING CONDITIONS,'' of the Model Falcon 2000EX AFM to include the information in figure 2 to paragraph (g)(2) of this AD, and thereafter operate the airplane accordingly. The AFM revision may be done by inserting a copy of this AD into the AFM. [[Page 44308]] [GRAPHIC] [TIFF OMITTED] TR22SE17.001 BILLING CODE 4910-13-C (h) New Actions: Inspection, Part Replacement, Part Re-Identification Within 9 months after the effective date of this AD: Do a detailed inspection of the wing anti-ice system ducting (anti-ice pipes) for the presence of a diaphragm, and do all applicable actions specified in paragraph (h)(1) or (h)(2) of this AD, in accordance with the Accomplishment Instructions of Dassault Service Bulletin F900EX-464, dated June 20, 2016; or Service Bulletin F2000EX-393, dated June 20, 2016; as applicable. After the applicable actions specified in paragraph (h)(1) or (h)(2) of this AD have been completed, the AFM revision required by [[Page 44309]] paragraph (g) of this AD may be removed from the AFM for that airplane. (1) If during the inspection required by the introductory text to paragraph (h) of this AD it is determined that a diaphragm is present: Before further flight, replace the wing anti-ice system ducting. (2) If during the inspection required by the introductory text to paragraph (h) of this AD it is determined that a diaphragm is not present: Before further flight, do a check of the anti-ice pipe part number and re-identify the wing anti-ice system ducting. (i) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention ofthe person identified in paragraph (j)(2) of this AD. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Section, Transport Standards Branch, FAA; or the European Aviation Safety Agency (EASA); or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Related Information (1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Emergency AD 2016-0130-E, dated July 5, 2016, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0494. (2) For more information about this AD, contact Tom Rodriguez, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1149. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Dassault Aviation Service Bulletin F900EX-464, dated June 20, 2016. (ii) Dassault Aviation Service Bulletin F2000EX-393, dated June 20, 2016. (3) For service information identified in this AD, contact Dassault Falcon Jet Corporation, Teterboro Airport, P.O. Box 2000, South Hackensack, NJ 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. (4) You may view this service information at the FAA, Transport Standards Branch, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.