2014-22-08: Time Limits and Maintenance Checks

Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): 2014-22-08 Airbus: Amendment 39-18013. Docket No. FAA-2014-0452; Directorate Identifier 2013-NM-185-AD. (a) Effective Date This AD becomes effective December 17, 2014. (b) Affected ADs None. (c) Applicability This AD applies to Airbus Model A318-111, -112, -121, and -122 airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and - 133 airplanes; Model A320-111, -211, -212, -214, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, - 231, and -232 airplanes; certificated in any category;all manufacturer serial numbers. (d) Subject Air Transport Association (ATA) of America Code 05, Time Limits and Maintenance Checks. (e) Reason This AD was prompted by a determination that more restrictive airworthiness limitations are necessary. We are issuing this AD to prevent a safety-significant latent failure (which is not annunciated) which, in combination with one or more other specific failures or events, would result in a hazardous or catastrophic failure condition. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Maintenance or Inspection Program Revision Within 30 days after the effective date of this AD, revise the maintenance or inspection program, as applicable, by incorporating Airbus A318/A319/A320/A321 Airworthiness Limitations Section (ALS) Part 3, Certification Maintenance Requirements (CMR), Revision 1, dated June 15, 2012. The initial compliance time for accomplishing the tasks specified in Airbus A318/A319/A320/A321 ALS Part 3, CMR, Revision 1, dated June 15, 2012, is at the applicable time specified in the Record of Revisions of Airbus A318/A319/A320/A321 ALS Part 3, CMR, Revision 1, dated June 15, 2012; or within 30 days after the effective date of this AD, whichever occurs later. (h) No Alternative Actions or Intervals After accomplishing the revisions required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions or intervals are approved as an alternative method of compliance in accordance with the procedures specified in paragraph (i) of this AD. (i) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your [[Page 67044]] request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Sanjay Ralhan, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057- 3356; telephone 425-227-1405; fax 425-227-1149. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport AirplaneDirectorate, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Related Information Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency Airworthiness Directive 2013-0148, dated July 16, 2013, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0452-0002. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Airbus A318/A319/A320/A321 Airworthiness Limitations Section (ALS) Part 3, Certification Maintenance Requirements (CMR), Revision 1, dated June 15, 2012. (ii) Reserved. (3) For service information identified in this AD, contact Airbus, Airworthiness Office--EIAS, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email [email protected]; Internet http://www.airbus.com. (4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.