The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2014-20-14: Flight Controls

FAA order 2014-20-14 is an airworthiness directive in force since November 12, 2014. The FAA's subject line: Flight Controls. It names Pacific Aerospace Ltd 750: about 9 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: flight controls.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Pacific Aerospace Limited
Models
750XL
On this site
Pacific Aerospace Ltd 750 9 registered

Dates and paperwork

In force since
November 12, 2014
Published
October 7, 2014 (signed September 26, 2014)
Docket
FAA-2014-0516
Replaces
2014-04-03
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are superseding Airworthiness Directive (AD) 2014-04-03 for all Pacific Aerospace Limited Model 750XL airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as broken control column attachment bolts failing in service. We are issuing this AD to require actions to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (5,565 characters)
Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by removing Amendment 39-17761 (79 FR 10344, February 25, 2014) and adding the following new AD: 2014-20-14 Pacific Aerospace Limited: Amendment 39-17987; Docket No. FAA-2014-0516; Directorate Identifier 2014-CE-021-AD. (a) Effective Date This airworthiness directive (AD) becomes effective November 12, 2014. (b) Affected ADs This AD supersedes AD 2014-04-03, Amendment 39-17761 (79 FR 10344, February 25, 2014). (c) Applicability This AD applies to Pacific Aerospace Limited Model 750XL airplanes, all serial numbers, certificated in any category. (d) Subject Air TransportAssociation of America (ATA) Code 27: Flight Controls. (e) Reason This AD was prompted from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as control column attachment bolts failing in service. We are issuing this AD to prevent failure of the control column attachment bolt, which could result in control column detachment and cause loss of control. (f) Actions and Compliance Unless already done, do the following actions in paragraphs (f)(1) and (f)(2) of this AD: (1) As of February 24, 2014 (the effective date of AD 2014-04- 03, Amendment 39-17761 (79 FR 10344, February 25, 2014)), if the left hand and the right hand control column attachment bolts have been replaced following the ACCOMPLISHMENT INSTRUCTIONS in Pacific Aerospace Limited Mandatory Service Bulletin PACSB/XL/070, Issue 1, dated January 24, 2014, then within the next 150 hours time-in- service (TIS) after November 12, 2014 (the effective date of this AD), replace the left hand and the right hand control column attachment bolts following the ACCOMPLISHMENT INSTRUCTIONS in Pacific Aerospace Limited Service Bulletin PACSB/XL/070, Issue 2, dated June 3, 2014. (2) As of February 24, 2014 (the effective date of AD 2014-04- 03, Amendment 39-17761 (79 FR 10344, February 25, 2014)), if the left hand and the right hand control column attachment bolts have not been replaced following the ACCOMPLISHMENT INSTRUCTIONS in Pacific Aerospace Limited Mandatory Service Bulletin PACSB/XL/070, Issue 1, dated January 24, 2014, then within the next 10 hours TIS after November 12, 2014 (the effective date of this AD), replace the left hand and the right hand control column attachment bolts following the ACCOMPLISHMENT INSTRUCTIONS in Pacific Aerospace Limited Service Bulletin PACSB/XL/070, Issue 2, dated June 3, 2014. (g) Other FAAAD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): (i) The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4123; fax: (816) 329-4090; email: [email protected]. (ii) AMOCS approved for AD 2014-04-03, Amendment 39-17761 (79 FR 10344, February 25, 2014) are not approved as AMOCs for this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (h) Related Information Refer to MCAI Civil Aviation Authority (CAA) AD DCA/750XL/15A, dated June 26, 2014, and Pacific Aerospace Limited Mandatory Service Bulletin PACSB/XL/070, Issue 1, dated January 24, 2014, for related information. You may examine the MCAI on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0516-0002. (i) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Pacific Aerospace Limited Service Bulletin PACSB/XL/070, Issue 2, dated June 3, 2014. (ii) Reserved. (3) For Pacific Aerospace Limited service information identified in this AD, contact Pacific Aerospace Limited, Hamilton Airport, Private Bag 3027 Hamilton 3240, New Zealand; telephone: +64 7 843 6144; fax: +64 7 843 6134; email: [email protected]; Internet: http://www.aerospace.co.nz/. (4) You may view this service information at FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/2014-20-14.json · aircraft systems.