The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2011-21-01: Fuel

FAA order 2011-21-01 is an airworthiness directive in force since November 16, 2011. The FAA's subject line: Fuel. System: other and general.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Fokker Services
Models
F.28 Mark 0070, F.28 Mark 0100, F.28 Mark 1000, F.28 Mark 2000, F.28 Mark 3000, F.28 Mark 4000, F27 Mark 050, F27 Mark 200, F27 Mark 300, F27 Mark 400, F27 Mark 500, F27 Mark 600, F27 Mark 700

Dates and paperwork

In force since
November 16, 2011
Published
October 12, 2011 (signed September 23, 2011)
Docket
FAA-2011-0568
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: [T]he Federal Aviation Administration (FAA) has published Special Federal Aviation Regulation (SFAR) 88, and the Joint Aviation Authorities (JAA) has published Interim Policy INT/POL/25/ 12. The review conducted by Fokker Services on the Fokker F27 and F28 type designs in response to these regulations revealed that, under certain failure conditions, a short circuit can develop in the fuel pilot valve solenoid or in the wiring to the solenoid. Such a short circuit may result in an ignition source in the wing tank vapour space. This condition, if not corrected, could result in a wing fuel tank explosion and consequent loss of the aeroplane. * * * ** We are issuing this AD to require actions to correct the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (9,641 characters)
Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2011-21-01 Fokker Services B.V.: Amendment 39-16824. Docket No. FAA- 2011-0568; Directorate Identifier 2011-NM-010-AD. Effective Date (a) This airworthiness directive (AD) becomes effective November 16, 2011. Affected ADs (b) None. Applicability (c) This AD applies to Fokker Services B.V. Model F.27 Mark 050, 200, 300, 400, 500, [[Page 63158]] 600, and 700 airplanes; and Fokker Services B.V. Model F.28 Mark 0070, 0100, 1000, 2000, 3000, and 4000 airplanes; certificated in any category; all serial numbers. Note 1: This AD requires revisions to certain operator maintenance documents to include a new Critical Design Configuration Control Limitation (CDCCL). Compliance with this CDCCL is required by 14 CFR 91.403(c). For airplanes that have been previously modified, altered, or repaired in the areas addressed by this AD, the operator may not be able to accomplish the actions described in the revisions. In this situation, to comply with 14 CFR 91.403(c), the operator must request approval for an alternative method of compliance (AMOC) according to paragraph (j)(1) of this AD. The request should include a description of changes to the required inspections that will ensure the continued operational safety of the airplane. Subject (d) Air Transport Association (ATA) of America Code 28: Fuel. Reason (e) The mandatory continuing airworthiness information (MCAI) states: [T]he Federal Aviation Administration (FAA) has published Special Federal Aviation Regulation (SFAR) 88, and the Joint AviationAuthorities (JAA) have published Interim Policy INT/POL/25/ 12. The review conducted by Fokker Services on the Fokker F27 and F28 type designs in response to these regulations revealed that, under certain failure conditions, a short circuit can develop in the fuel pilot valve solenoid or in the wiring to the solenoid. Such a short circuit may result in an ignition source in the wing tank vapour space. This condition, if not corrected, could result in a wing fuel tank explosion and consequent loss of the aeroplane. * * * * * Compliance (f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Installation of Fuses Packed in Jiffy Junctions (g) Within 24 months after the effective date of this AD, re- work the wiring and install the fuses packed in jiffy junctions (i.e., crimped wire in-line junction device), in accordance with the Accomplishment Instructions of the applicable Fokker service bulletin identified in table 1 of this AD. Table 1--Service Bulletins ------------------------------------------------------------------------ Fokker Service Bulletin-- Dated-- ------------------------------------------------------------------------ SBF50-28-024, including Drawing W7916-057, June 23, 2010. Sheets 006 and 007, Issue E, dated June 23, 2010, Drawing W7987-520, Sheets 1 and 2, dated October 24, 2005, and Manual Change Notification--Maintenance Document MCNM-F50- 070, dated June 23, 2010. SBF28-28-051, including Drawing W57231, Sheets June 23, 2010. 010 and 011, Issue K, dated June 23, 2010, Drawing W58048, Sheet 2, dated April 29, 2010, and Manual Change Notification-- Maintenance Document MCNM-F28-034, dated June 23, 2010. SBF27-28-069, including Drawing W7202-138, June 23, 2010. Sheets 001 and 002, Issue B, dated June 23, 2010, and Manual Change Notification--Maintenance Document MCNM-F27-025, dated June 23, 2010. SBF100-28-042, including Drawing W41192, Sheet June 23, 2010. 012, Issue AG, dated June 23, 2010, Drawing W59520, Sheet 1, Issue A, dated April 29, 2010, and Manual Change Notification-- Maintenance Document MCNM-F100-129, dated June 23, 2010. ------------------------------------------------------------------------ Critical Design Configuration Control Limitation (CDCCL) (h) Before further flight after doing the actions required by paragraph (g) of this AD: Revise the aircraft maintenance program by incorporating the CDCCL specified in paragraph 1.L.(1)(c) of the applicable Fokker service bulletins identified in table 1 of this AD. No Alternative Actions, Intervals, and/or CDCCLs (i) After accomplishing the revision required by paragraph (h) of this AD, no alternative CDCCLs may be used unless the CDCCLs are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j)(1) of this AD. FAA AD Differences Note 2: This AD differs from the MCAI and/or service information as follows: Although European Aviation Safety Agency (EASA) Airworthiness Directive 2010-0195, dated September 29, 2010, specifies revising the maintenance program to include maintaining CDCCLs, this AD only requires the revision. Requiring a revision of the maintenance program, rather than requiring maintaining CDCCLs, requires operators to record AD compliance only at the time the revision is made. Maintaining CDCCLs specified in the airworthiness limitations must be complied with in accordance with 14 CFR 91.403(c). Other FAA AD Provisions (j) The following provisions also apply to this AD: (1) Alternative Methods of Compliance: The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordancewith 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone 425-227-1137; fax 425-227-1149. Information may be e-mailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority(or their delegated agent). You are required to assure the product is airworthy before it is returned to service. Related Information (k) Refer to MCAI EASA Airworthiness Directive 2010-0195, dated September 29, 2010, and the Fokker service bulletins identified in table 1 of this AD, for related information. Material Incorporated by Reference (l) You must use the following service information, as applicable, to do the actions required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference (IBR) under 5 U.S.C. 552(a) and 1 CFR part 51 of the following service information on the date specified. (1) Fokker Service Bulletin SBF50-28-024, including Manual Change Notification--Maintenance Document MCNM-F50-070, dated June 23, 2010, and including Drawing W7916-057, Sheets 006 and 007, Issue E, dated June 23, 2010, and Drawing W7987-520, Sheets 1 and 2, dated October 24, 2005, approved for IBR November 16, 2011. (2) Fokker Service Bulletin SBF28-28-051, including Manual Change Notification--Maintenance Document MCNM-F28-034, dated June 23, 2010, and including Drawing W57231, Sheets 010 and 011, Issue K, dated June 23, 2010, and Drawing W58048, Sheet 2, dated April 29, 2010, approved for IBR November 16, 2011. (3) Fokker Service Bulletin SBF27-28-069, including Manual Change Notification--Maintenance Document MCNM-F27-025, dated June 23, 2010, and including Drawing W7202-138, Sheets 001 and 002, Issue B, [[Page 63159]] dated June 23, 2010, approved for IBR November 16, 2011. (4) Fokker Service Bulletin SBF100-28-042, including Manual Change Notification--Maintenance Document MCNM-F100-129, dated June 23, 2010, and including Drawing W41192, Sheet 012, Issue AG, dated June 23, 2010, and Drawing W59520, Sheet 1, Issue A, dated April 29, 2010, approved for IBR November 16, 2011. (5) For service information identified in this AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 231, 2150 AE Nieuw-Vennep, the Netherlands; telephone +31 (0)252-627-350; fax +31 (0)252-627-211; e-mail [email protected]; Internet: http://www.myfokkerfleet.com. (6) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (7) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/2011-21-01.json · aircraft systems.