2010-23-03: Fuel

2010-23-03 The Boeing Company: Amendment 39-16492; Docket No. FAA- 2010-1040; Directorate Identifier 2010-NM-207-AD. \n\nEffective Date \n\n\t(a) This AD is effective November 22, 2010. \n\nAffected ADs \n\n\t(b) None. \n\nApplicability \n\n\t(c) This AD applies to The Boeing Company Model 757-200, 200CB, -200PF, and -300 series airplanes, line numbers 1 through 1050 inclusive, and all Model 767-200, -300, -300F, and -400ER series airplanes; certificated in any category. \n\nSubject \n\n\t(d) Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 28: Fuel. \n\nUnsafe Condition \n\n\t(e) This AD was prompted by a report that the EICAS failed to alert the flightcrew of an improper fuel system configuration during flight. Later in that flight the EICAS failed to alert the flightcrew that the fuel in the left- and right-hand main tanks was depleted below the minimum of 2,200 pounds. We are issuing this AD to detect and correct a single latent failure of the FUELCONFIG discrete signal, which disables both the FUEL CONFIG and LOW FUEL messages. Such failure, combined with a flightcrew error in configuring the fuel system, could lead to depletion of the fuel in the main tanks and possible flame out of both engines. A dual engine flame out could result in inaccessibility of the remaining fuel in the center tank due to loss of electrical power to the pumps, consequent unrecoverable dual engine shutdown, and forced landing of the airplane. \n\nCompliance \n\n\t(f) Comply with this AD within the compliance times specified, unless already done. \n\nRepetitive Tests \n\n\t(g) Within 100 flight hours after the effective date of this AD: Do a test for correct functioning of the EICAS to ensure that it receives both the LOW FUEL and FUEL CONFIG discrete signals from the fuel quantity processor unit, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 757-28- 0121, dated August 18, 2010; or Boeing Special Attention Service Bulletin 767-28-0106, dated August 25, 2010; as applicable. Repeat the test thereafter at intervals not to exceed 100 flight hours. \n\nCorrective Actions If Necessary \n\n\t(h) If any test required by paragraph (g) of this AD fails, before further flight, troubleshoot to find any wire faults, and damaged equipment (including bent connector pins), in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 757-28-0121, dated August 18, 2010; or Boeing Special Attention Service Bulletin 767-28-0106, dated August 25, 2010; as applicable. \n\n\t(i) If, during any troubleshooting required by paragraph (h) of this AD, any wire fault or damaged equipment (including bent connector pins) is found, before further flight, do the applicable actions specified in paragraph (i)(1) or (i)(2) of this AD. \n\n\t(1) For airplanes identified in Boeing Special Attention Service Bulletin 757-28-0121, dated August 18, 2010: Repair or replace affected wires and equipment (including bent connector pins), in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 757-28-0121, dated August 18, 2010. \n\n\t(2) For airplanes identified in Boeing Special Attention Service Bulletin 767-28-0106, dated August 25, 2010: Do corrective actions using a method approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA. \n\n\tNote 1: Guidance on doing corrective actions can be found in Chapter 28, Subject 28-41-00, Section July, of the Boeing 767 Fault Isolation Manual (FIM). \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(j)(1) The Manager, Seattle ACO, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified inthe Related Information section of this AD. Information may be e-mailed to: 9-ANM-Seattle-ACO-AMOC- [email protected]. \n\n\t(2) Before using any approved AMOC, notify your Principal Maintenance Inspector or Principal Avionics Inspector, as appropriate, or lacking a principal inspector, your local Flight Standards District Office. \n\nRelated Information \n\n\t(k) For more information about this AD, contact Tak Kobayashi, Aerospace Engineer, Propulsion Branch, ANM-140S, FAA, Seattle ACO, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6499; fax (425) 917-6590; e-mail [email protected]. \n\nMaterial Incorporated by Reference \n\n\t(l) You must use Boeing Special Attention Service Bulletin 757- 28-0121, dated August 18, 2010; or Boeing Special Attention Service Bulletin 767-28-0106, dated August 25, 2010; as applicable; to do the actions required by this AD, unless the AD specifies otherwise. \n\n\t(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. \n\n\t(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, Washington 98124-2207; telephone 206-544-5000, extension 1, fax 206-766-5680; e-mail [email protected]; Internet https://www.myboeingfleet.com. \n\n\t(3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. \n\n\t(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at an NARA facility, call 202-741-6030, or go to http:// www.archives.gov/federal_register/code_of_federal_regulations/ ibr_locations.html.