2000-21-07: Critical Life-Limited Parts

2000-21-07 Pratt & Whitney: Amendment 39-11939. Docket 98-ANE-43-AD. Supersedes AD 99-12-04, Amendment 39-11188. Applicability: Pratt & Whitney (PW) JT8D-200 series turbofan engines, installed on but not limited McDonnell Douglas MD-80 series airplanes. Note 1: This airworthiness directive (AD) applies to each engine identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For engines that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it. Compliance: Required as indicated, unless accomplished previously. To prevent critical life-limited rotating engine part failure, which could result in an uncontained engine failure and damage to the airplane, accomplish the following: Inspections (a) Within the next 30 days after the effective date of this AD, revise the Time Limits Section (TLS) of the JT8D-200 Turbofan Engine Manual, and for air carrier operations revise the approved continuous airworthiness maintenance program, by adding the following: "Critical Life Limited Part Inspection A. Inspection Requirements: (1) This section contains the definitions for individual engine piece-parts and the necessary inspection procedures when these parts are removed from the engine. (2) It is necessary to do the inspection procedures of the piece-parts in Paragraph B when: (a) The part is removed from the engine and disassembled to the level specified in paragraph B and (b) The part has accumulated more than 100 cycles since the last piece part inspection, provided that the part is not damaged or related to the cause of its removal from the engine. (3) The inspections specified in this section neither replace nor negate other recommended inspections for these parts or other parts. B. Parts Requiring Inspection. Note: Piece part is defined as any of the listed parts with all the blades removed. DESCRIPTION ENGINE MANUAL SECTION INSPECTION Hub (Disk), 1st Stage Compressor: 5000501-01 (Hub detail) 72-33-31 -02,-03 5000421-01 (Hub assembly) 72-33-31 -02,-03 HP Turbine Disk, First Stage: 804301 72-52-02 -03 5004501-01 72-52-02 -03 856701 72-52-02 -03 5004301-01 72-52-02 -03 832201 72-52-02 -03 855701 72-52-02 -03 856601 72-52-02 -03" (b) Except as provided in paragraph (c) of this AD, and notwithstanding contrary provisions in section 43.16 of the Federal Aviation Regulations (14 CFR 43.16), these mandatory inspections shall be performed only in accordance with the TLS of the PW JT8D-200 Turbofan Engine Manual. Alternative Methods of Compliance (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Engine Certification Office (ECO). Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector (PMI), who may add comments and then send it to the ECO. Note 2: Information concerning the existence of approved alternative methods of compliance with this airworthiness directive, if any, may be obtained from the ECO. Ferry Flights (d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Continuous Airworthiness Maintenance Program (e) FAA-certificated air carriers that have an approved continuous airworthiness maintenance program in accordance with the record keeping requirement of 121.369 (c) of the Federal Aviation Regulations [14 CFR 121.369 (c)] must maintain records of the mandatory inspections that result from revising the TLS of the PW JT8D-200 Turbofan Engine Manual, and the air carrier's continuous airworthiness program. Alternately, certificated air carriers may establish an approved system of record retention that provides a method for preservation and retrieval of the maintenance records that include the inspections resulting from this AD, and include the policy and procedures for implementing this alternate method in the air carrier's maintenance manual required by 121.369 (c) of the Federal Aviation Regulations [14 CFR 121.369 (c)]; however, the alternate system must be accepted by the appropriate PMI and require the maintenance records be maintained either indefinitely or until the work is repeated. Records of the piece-part inspections are not required under 121.380 (a) (2) (vi) of the Federal Aviation Regulations [14 CFR 121.380 (a) (2) (vi)]. All other operators must maintain the records of mandatory inspections required by the applicable regulations governing their operations. Note 3: The requirements of this AD have been met when the engine manual changes are made and air carriers have modified their continuous airworthiness maintenance plans to reflect the requirements in the PW JT8D-200 Turbofan Engine Manual. (f) This amendment becomes effective on April 23, 2001.