SR01179SE

Fabrication of the Winco Side Pull Handle Assembly per Drawing No. W002, Revision N/C, dated December 13, 2002, or later FAA-approved revision, and the Hook Link Assembly, Part No. 369SP-200, per Colorado Helicopters Drawing No. 369SP-200, Revision C, dated September 11, 1991, or later FAA-approved revision; and installation and maintenance of this system. Held by Winco INC., which holds 2 approved modifications in all. Last revised June 29, 2009. System: other and general.

What it applies to

Kind of product: Aircraft
Design holder: MD Helicopter Inc.; MD Helicopter Inc.; MD Helicopter Inc.; MD Helicopter Inc.; MD Helicopter Inc.
Models: 369D, 369E, 369F, 369FF, 500N
Type certificates: H3WE, H3WE, H3WE, H3WE, H3WE
On this site: Md Helicopters Inc 369 108 registered
Md Helicopters Inc 500 14 registered
The FAA's record: On the FAA's site

What an approved modification is

A supplemental type certificate is the FAA's approval of a change to a certified design: a new engine or propeller, avionics, an autopilot, floats, a parachute, a larger fuel tank, an ice-protection kit. The company holding it may sell the kit and the paperwork to owners of the listed models; the modification then becomes part of that aircraft's record. The FAA's list says what was approved and for which models, not how many aircraft carry it.

Source: FAA supplemental type certificates (Dynamic Regulatory System). Register counts from the FAA register of October 21, 2026.