The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2009-22-14: Main equipment center

FAA order 2009-22-14 is an airworthiness directive in force since December 8, 2009. The FAA's subject line: Main equipment center. It names Boeing 747: about 192 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: electrical power.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
747-200C Series, 747-200F Series
On this site
Boeing 747 192 registered

Dates and paperwork

In force since
December 8, 2009
Published
November 3, 2009 (signed October 19, 2009)
Docket
FAA-2008-1362
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are adopting a new airworthiness directive (AD) for certain Boeing Model 747-200C and 747-200F series airplanes. This AD requires installing larger moisture shrouds and additional drain lines in the electrical/electronic equipment center. This AD results from reports of water contamination in the electrical/electronic units in the main equipment center. We are issuing this AD to prevent water contamination in the electrical/electronic units in the main equipment center, which could result in an electrical short and potential loss of several functions essential for safe flight.

The order itself the regulatory text, as published

Show the full text (5,030 characters)
2009-22-14 Boeing: Amendment 39-16067. Docket No. FAA-2008-1362; Directorate Identifier 2008-NM-150-AD. \n\nEffective Date \n\n\t(a) This airworthiness directive (AD) is effective December 8, 2009. \n\nAffected ADs \n\n\t(b) None. \n\nApplicability \n\n\t(c) This AD applies to Boeing Model 747-200C and 747-200F series airplanes, certificated in any category, as identified in Boeing Alert Service Bulletin 747-25A3431, dated March 6, 2008. \n\nUnsafe Condition \n\n\t(d) This AD results from reports of water contamination in the electrical/electronic units in the main equipment center. We are issuing this AD to prevent water contamination in the electrical/ electronic units in the main equipment center, which could result in an electrical short and potential loss of several functions essential for safe flight. \n\nCompliance \n\n\t(e) Comply with this AD within the compliance times specified, unless already done. \n\nInstallation of Shrouds and Drain Lines \n\n\t(f) Within 72 months after theeffective date of this AD, install larger moisture shrouds and additional drain lines, by doing all the applicable actions specified in the Accomplishment Instructions of Boeing Alert Service Bulletin 747-25A3431, dated March 6, 2008. \n\nInstallation of Moisture Curtains \n\n\t(g) Prior to or concurrently with accomplishing the actions required by paragraph (f) of this AD: Install protective moisture curtains in the main equipment center in accordance with Boeing Service Bulletin 747-25A3430, Revision 1, dated October 9, 2008. \n\n\tNote 1: The installation required by paragraph (g) of this AD is the same installation required by paragraph (f) of AD 2007-26-03, amendment 39-15305, for Boeing Model 747-200C and -200F series airplanes (AD 2007-26-03 specifies that the actions be done in accordance with Boeing Alert Service Bulletin 747-25A3430, dated February 15, 2007). Boeing Service Bulletin 747-25A3430, Revision 1, dated October 9, 2008, which affects Boeing Model 747-200F airplanes,variable numbers RR566 and RR551 through RR556 inclusive, is an alternative method of compliance for the requirements of paragraph (g) of AD 2007-26-03. Airplanes identified as Group 1, Group 3, and Group 6 airplanes in Boeing Service Bulletin 747- 25A3430, Revision 1, dated October 9, 2008, must comply with paragraph (g) of AD 2007-26-03. \n\nInstallations Accomplished According to Previous Issue of Service Bulletin \n\n\t(h) Installations accomplished before the effective date of this AD in accordance with Boeing Alert Service Bulletin 747-25A3430, dated February 15, 2007, are considered acceptable for compliance with the corresponding action, paragraph (g) of this AD. \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(i)(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Marcia Smith, Aerospace Engineer, Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6484; fax (425) 917-6590. Or, e-mail information to [email protected]. \n\t(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. \n\nMaterial Incorporated by Reference \n\n\t(j) You must use Boeing Alert Service Bulletin 747-25A3431, dated March 6, 2008; and Boeing Service Bulletin 747-25A3430, Revision 1, dated October 9, 2008; as applicable; to do the actions required by this AD, unless the AD specifies otherwise. \n\t(1) The Director ofthe Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, Washington 98124-2207; telephone 206-544-5000, extension 1, fax 206-766-5680; e-mail [email protected]; Internet https://www.myboeingfleet.com. \n\t(3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. \n\t(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http:// www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

Related safety bulletins advice on the same designs, not orders

2020-11-16AIR-20-18 · Flight Management Computing Software System
2020-04-16NM-20-07 · Navigation - Glideslope System
2018-12-17NM-18-33 · Engine Fuel and Control
2017-04-13NM-17-10 · Maintenance Practices
2014-11-24NM-15-03 · Flight Controls

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of October 30, 2026. Connections as data: /graph/directive/2009-22-14.json · aircraft systems.