Cessna 310N accident near Wickenburg, Arizona, September 9, 2016

The NTSB's narrative final · quoted from the NTSB record

The airline transport pilot and three passengers were departing in the multi-engine airplane when, during the early phase of takeoff, most likely shortly after rotation, the right engine experienced a total loss of power. The power loss occurred during a critical phase of flight, at a time when the airplane was close to or just below the manufacturer's recommended "safe single-engine speed." The hilly terrain surrounding the airport, particularly in the takeoff direction, left the pilot with few options for a safe climb out. Further hindering the takeoff was the airplane's anemic single-engine climb performance due to the high density altitude conditions and the airplane's weight. As a result, shortly after the loss of power, the airplane rolled right, consistent with it flying slower than its minimum controllable single-engine airspeed, collided with the ground, and sustained substantial damage. The pilot and passengers all sustained serious injuries and could not remember the circumstances of the accident. Examination of the right engine revealed that a clear, gelatinous substance had blocked the inlet port of the fuel flow transducer, leading to fuel starvation. The substance was determined to be silicone, most likely room-temperature-vulcanization silicone sealant. There were no indications that this material had been used anywhere within the fuel system, nor were there any signs of recent maintenance that could have resulted in the introduction of this contaminant. To get to the fuel flow transducer, the silicone would have had to pass through multiple fine mesh filters, which was unlikely based on the material's size when dry. However, silicone becomes semi-soluble once in contact with aviation gasoline, and it is possible that it was extruded through the filters in this state, and eventually coalesced in the flow divider inlet port. Smaller fragments of the silicone were found in the fuel manifold valve, beyond the flow divider, and a fuel injector valve port was partially occluded, possibly with the same material. The specific source of contamination could not be determined. The pilot last purchased fuel for the airplane about one month before the accident. Later on the day of purchase, the fuel system was shut down by the airport management due to metering inaccuracies; however, the problems were all electrical in nature, and did not require the repair or replacement of any components that would have come into contact with fuel.

The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.

Other NTSB records under N126P the same tail number, which may have belonged to a different aircraft at the time