Amateur-built PETERSON A600 accident near Foley, Alabama, April 6, 2023

The NTSB's narrative final · quoted from the NTSB record

The pilot of the experimental amateur-built helicopter reported that he had hovered around the airport for about 20 minutes without issue and then initiated a takeoff to remain in the traffic pattern. During the initial climb, about 20 to 30 ft above ground level, the engine suddenly lost power and the helicopter yawed to the right. The pilot entered an autorotation and performed a run-on landing on a grass surface. During the landing, the right skid dug into uneven terrain, the helicopter rolled over onto its right side, and a post-crash fire quickly ignited. The pilot was able to extract himself from the helicopter without injury, however, the helicopter was destroyed by the post-impact fire. The pilot reported that after the accident, he discovered an undamaged turbocharger air intake hose clamp directly in his departure path in the grass. Photographs of the turbocharger revealed that the air intake clamp was not installed, and the intake hose had been consumed by fire. The pilot reported that about a week prior to the accident, while the helicopter was being transported on a trailer, he personally adjusted this clamp and intake hose, and he may have forgotten to tighten the clamp. During the initial climb, it is likely that the turbocharger intake hose and clamp separated from its installation area, and as a result, engine power was lost.

The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.