Quicksilver MX-2 accident near Lake City, Florida, September 2, 2010

The NTSB's narrative final · quoted from the NTSB record

The pilot completed a preflight inspection of the airplane and a run-up check of the engine, noting no anomalies. During the initial climb, the pilot noted that the engine coolant temperature had risen above its normal range, and he responded by reducing engine power. He also turned the airplane left toward the overrun area for a perpendicular runway. The engine coolant temperature continued to rise as the pilot pitched the airplane for the best glide speed. As the pilot continued to maneuver the airplane, the sink rate was increasing, so he applied full power, with no accompanying response from the engine. During the attempted landing, the pilot gradually lost control of the airplane as it slowed, and subsequently struck a pool enclosure attached to a home. A postaccident examination of the engine found contamination within the carburetors; the pistons, connecting rods, and crankcase exhibited a black/brown glaze; and the lower piston rings exhibited extreme carbon build-up; however, no definitive cause for the rise in engine coolant temperature or the reported partial loss of engine power could be determined. The reported temperature and dew point at an airport located 34 nautical miles from the accident site were conducive to the formation of "serious" carburetor icing at glide engine power settings; however, given that the engine was operating at a very high power output when the reported loss of power occurred, it was unlikely that carburetor icing contributed to the partial loss of engine power.

The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.

Other NTSB records under N7108Z the same tail number, which may have belonged to a different aircraft at the time