Cub Crafters INC CC18-180 accident near Anchorage, Alaska, November 2, 2024
On November 2, 2024 at about 10:36 pm local time, a 2019 Cub Crafters INC CC18-180, registered N55PK, was substantially damaged in an accident during takeoff near Anchorage, Alaska (Lake Hood Airport). It was a public-use flight under public-use (government) rules. 1 person was seriously injured. The weather was visual conditions (good weather).
Preview. This page is not yet listed for search engines.
The NTSB's probable cause their words, unchanged
The incorrect installation of the rear flight control stick, resulting in the pilot’s inability to control the pitch attitude, coupled with the pilot’s inadequate control system check before departure, all which resulted in an aerodynamic stall during takeoff.
Source: NTSB aviation accident database, copy made October 4, 2026. Docket and reports at the NTSB.
What the record shows
- Date
- November 2, 2024 · about 10:36 pm local time
- Place
- Anchorage, Alaska · Lake Hood Airport · map
- Type
- Accident
- Injuries
- 1 person was seriously injured.
- Weather
- visual conditions (good weather)
- Aircraft
- Cub Crafters INC CC18-180, built 2019 · all CC18-180s on the register
- Registration
- N55PK · registry record · serial CC18-0096
- Damage
- Substantial damage
- Flight
- Public-use flight · public-use (government) rules
The NTSB's narrative final · quoted from the NTSB record
The pilot reported that during takeoff, just after becoming airborne, he was unable to move the flight control stick forward. The airplane started climbing aggressively and the pilot attempted to recover using elevator trim control. The airplane subsequently stalled and began an uncontrolled, nose-down descent toward the runway. During the descent, the pilot was able to level the airplane; however, there was insufficient altitude to recover from the stall. The airplane impacted the runway, resulting in substantial damage to the fuselage and both wing lift struts. The accident pilot reported that just before departure, he did a control system check, which did not reveal any anomalies. A postaccident examination revealed that the rear flight control stick was incorrectly installed. The flight control stick was installed in reverse. The curve of the control stick was curved forward, which resulted in the control stick contacting the pilot’s (front) seatback, which limited movement and prevented the control stick from moving full forward. The investigation did not determine who improperly installed the control stick. However, it was normal practice for the pilots to remove and reinstall the rear seat control stick if they were flying with just cargo in the rear seat area. The pilot reported that he has never removed the control stick and was not trained to do so. Had the pilot been trained on the removal and installation of the control stick, he may have noticed the control stick was installed backwards during his preflight. He also stated that he was not aware that the control stick could be installed incorrectly. The airplane manufacturers’ supplement dated January 13, 2016, which describes the process and requirements for reinstalling the rear control stick, states in part: “Ensure full range of motion (including trim) is met without the rear stick contacting anything.” Additionally, the supplement must be added to the pilot’s operating handbook and the Federal Aviation Administration approved flight manual when the rear control stick is removed and reinstalled. Following the accident, the operator issued an agency safety alert to address the correct installation of the rear flight control stick. Additionally, the safety alert highlights the preflight and before takeoff checklists requiring flight control checks to verify the maximum range of travel.
The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.
The factual record from the NTSB's investigation tables, in plain English
What happened, in order
- Loss of control in flight during takeoff
- Flight control sys malf/fail during takeoff defining event
The NTSB's findings
- Personnel issues › Experience/knowledge › Training › Training with equipment › Pilot
- Personnel issues › Task performance › Inspection › Preflight inspection › Pilot
- Personnel issues › Experience/knowledge › Knowledge › Knowledge of equipment › Pilot
- Personnel issues › Experience/knowledge › Knowledge › Knowledge of equipment › Maintenance personnel
- Personnel issues › Action/decision › Info processing/decision › Identification/recognition › Pilot
- Organizational issues › Support/oversight/monitoring › Training › Initial training › Operator
- Organizational issues › Support/oversight/monitoring › Training › Initial training › Manufacturer
- Organizational issues › Management › Policy/procedure › Adequacy of policy/proc › Manufacturer
- Organizational issues › Development › Design › Equipment design › Manufacturer
- Aircraft › Aircraft systems › Flight control system › Control column section › Incorrect service/maintenance
Pilot
- Certificate: commercial pilot, flight engineer
- Ratings: multi-engine land; single-engine land; single-engine sea; instructor: airplane multi-engine; instructor: airplane single-engine; instructor: instrument airplane; instrument: airplane
- Flight time: 2,014 hours in all; 18 in the last 90 days; 0 in the last 30 days; 1,856 as pilot in command; 1,284 on instruments
- Last flight review: June 21, 2024
- Medical certificate: Class 2 (without waivers/limitations)
- Seat: frt
- Injury: serious injuries
The aircraft
- Airframe total time: 353.3 hours
- Last inspection: annual inspection, July 31, 2024; 25.6 hours since
- Maximum gross weight: 2,300 lb
- Seats: 2
- Landing gear: fixed
- Engine: Lycoming O-360-C1G (piston); 353 hours total
The flight
- Destination: FAI Fairbanks AK
- Flight plan: VFR
- Runway 32, 2,200 ft by 75 ft
Weather at the time
- Light: daylight
- Wind: from 040° at 4 knots
- Visibility: 10 statute miles
- Sky: overcast at 8,000 ft; scat at 6,500 ft
- Temperature: 34°F (1°C), dew point 30°F (-1°C)
- Altimeter: 29.27 inHg
- Observation at 2:53 pm from PALH
Weather report (METAR): PALH 022253Z AUTO 04004KT 10SM SCT065 OVC080 01/M01 A2927 RMK AO2 SLP913 T00111011 TSNO
Injuries
| Fatal | Serious | Minor | None | |
|---|---|---|---|---|
| Flig | 1 |
Documents from the investigation the NTSB's docket: the evidence folder behind the report
The NTSB has not released the docket for this case yet. The docket, the folder of records gathered during an investigation (maintenance records, photographs, witness statements, examinations), is usually released when the investigation is nearly complete, and the list here is refreshed when it appears. Check at the NTSB.
About this page
Everything above comes from the NTSB's public accident database: the narrative, probable cause and findings are the NTSB's own words, and the coded tables behind its report (pilot, aircraft, flight, weather, injuries, sequence of events) are written out in plain English. Pilots' ages, home towns and medical details are left out on purpose. The documents and photographs are the NTSB's docket, the folder of records gathered during the investigation, shown as the NTSB released them (the NTSB redacts some personal details first) and listed under the NTSB's own titles. This site's own text never names pilots, passengers or anyone else involved. A preliminary report describes what is known soon after the event and can change; the final report, with the probable cause, usually follows one to two years later and this page is refreshed when it does. Case number ANC25LA008.
