The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · historical

93-25-07: Fuselage Stringers

FAA order 93-25-07 is an airworthiness directive in force since February 15, 1994. The FAA's subject line: Fuselage Stringers. It names Beechcraft A100, Beechcraft A200, Beechcraft B200 King Air B200, Beechcraft B300 King Air 350: about 1,551 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: airframe structure.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Raytheon Aircraft Company
Models
200 Model or Series (all), 200C, 200CT, 200T, 300, A100-1 (U-21J), A200, A200 (C-12A), A200 (C-12C), A200C (UC-12B), A200CT (C-12D), A200CT (C-12F), A200CT (FWC-12D), A200CT (RC-12D), A200CT (RC-12G), A200CT (RC-12H), A200CT (RC-12K), A200CT (RC-12P), A200CT (RC-12Q), B200, B200C, B200CT, B200T, B300, B300C
On this site
Beechcraft A100 15 registered
Beechcraft A200 34 registered
Beechcraft B200 King Air B200 718 registered
Beechcraft B300 King Air 350 784 registered

Dates and paperwork

In force since
February 15, 1994
Docket
93-CE-38-AD
Replaced by
2005-01-18
Status
Historical
The FAA's document
Read the order on the FAA's site

The order itself the regulatory text, as published

Show the full text (4,539 characters)
93-25-07 BEECH AIRCRAFT CORPORATION: Amendment 39-8773. Docket No. 93-CE-38-AD. Applicability: The model and serial number airplanes presented below, certificated in any category, that do not have all the fuselage stringers Nos. 5 through 11 modified on both the right and left hand sides in accordance with either (1) Beech Service Bulletin (SB) 2472, Revision 1, dated September 1993; (2) Chapter 51-10 or 53-10, as applicable, of the maintenance manual; or (3) the instructions to Priester Aviation Service Supplemental Type Certificate (STC) SA63CH: Models Serial Numbers 200, A200, B200, and A100-1 BB-2 through BB-1462, BC-1 through BC-75, and BD-1 through BD-30 200C, A200C, and B200C BL-1 through BL-138, BJ-1 through BJ-66, BU-1 through BU-12, and BV-1through BV-12 200CT, A200CT, B200CT BN-1 through BN-4, BP-1 through BP-71, FC-1, FC-2, FC-3, FE-1 through FE-31, FG-1, FG-2, and GR-1 through GR-19 200T and B200T BT-1 through BT-38 300 FA-1 through FA-228 300 (FAA) FF-1 through FF-19 B300 FL-1 through FL-103 B300C FM-1 through FM-8 and FN-1 Compliance: Required upon the accumulation of 3,000 hours time-in-service (TIS) or within the next 100 hours TIS after the effective date of this AD, whichever occurs later, unless already accomplished, and thereafter as indicated. To prevent structural damage to the fuselage caused by cracked stringers in the rear pressure bulkhead area, accomplish the following: (a) Inspect fuselage stringers Numbers (Nos.) 5 through 11 on both the left and right hand sides for cracks in accordance with the ACCOMPLISHMENT INSTRUCTIONS section of Beech SB No. 2472, Revision 1, dated September 1993. (1) If no cracks are found, reinspect at intervals that correspond with the following: Stringers Modified in Accordance With One of the Three Modifications Referenced in the Applicability Section of this AD Inspection Interval No Stringers Modified 600 hours TIS on all stringers Nos. 8, 9, and 10 (one side) with Internal Modification 1,200 hours TIS on unmodified stringers Nos. 8, 9, and 10 (one side) with External Modification 600 hours TIS on unmodified stringers Nos. 5 through 11 AD no longer applies (2) If cracks are found, modify all cracked fuselage stringers at any time up to the time specified in the chart presented in paragraph (a)(3) of this AD. Accomplish this modification in accordance with the instructions in one of the three modifications specified in the Applicability section of this AD, and reinspect at intervals presented in the chart in paragraph (a)(1) of this AD. (3) The following chart specifies the required compliance time where cracked stringers must be modified: No. of Stringers Cracked on Any One Side of Fuselage When Modification Must be Accomplished (Hours TIS) 1 to 3 150 4 30 5 or more Prior to further flight (b) The modifications specified in the Applicability section of this AD may be accomplished at any time as terminating action for the inspection requirement of this AD provided that all fuselage stringers Nos. 5 through 11 are modified. (c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished. (d) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, 1801 Airport Road, Room 100, Wichita, Kansas 67209. The request should be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and send it to the Manager, Wichita ACO. NOTE: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO. (e) The inspections and modification required by this AD shall be done in accordance with Beech Service Bulletin 2472, Revision 1, dated September 1993. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from the Beech Aircraft Corporation, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Central Region, Office of the Assistant Chief Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. (f) This amendment (39-8773) becomes effective on February 15, 1994.

Related safety bulletins advice on the same designs, not orders

2026-09-102026-16 · Elevator Control System
2015-04-20CE-15-15 · Empennage Horizontal & Vertical Stabilizer Structure
2013-08-30CE-10-34R2 · Alternative Methods of Compliance (AMOC) to Airworthiness Directive (AD) 89-25-10 and 89-25-08
2013-08-20CE-10-34R1 · Alternative Methods of Compliance (AMOC) to Airworthiness Directive (AD) 89-25-10 and 89-25-08
2012-06-19CE-12-36 · Flight Controls: Aileron

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of October 5, 2026. Connections as data: /graph/directive/93-25-07.json · aircraft systems.