The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

91-22-07: MLG Outboard Door

FAA order 91-22-07 is an airworthiness directive in force since December 3, 1991. The FAA's subject line: MLG Outboard Door. It names Douglas DC-9, Mcdonnell Douglas DC-9: about 100 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: airframe structure.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
DC-9-11, DC-9-12, DC-9-13, DC-9-14, DC-9-15, DC-9-15F, DC-9-21, DC-9-31, DC-9-32, DC-9-32 (VC-9C), DC-9-32F, DC-9-32F (C-9A), DC-9-32F (C-9B), DC-9-33F, DC-9-34, DC-9-34F, DC-9-41, DC-9-51
On this site
Douglas DC-9 7 registered
Mcdonnell Douglas DC-9 93 registered

Dates and paperwork

In force since
December 3, 1991
Docket
91-NM-88-AD
Status
Current
The FAA's document
Read the order on the FAA's site

The order itself the regulatory text, as published

Show the full text (4,166 characters)
91-22-07 MCDONNELL DOUGLAS: Amendment 39-8067. Docket No. 91-NM-88-AD. Supersedes AD 91-03-07, Amendment 39-6869. \n\n\tApplicability: Model DC-9-10, -20, -30, -40, and -50 series and C-9 (Military) series airplanes; fitted with left (LH) or right (RH) main landing gear (MLG) outboard door with a wing-mounted aluminum hinge half (Group I) or titanium hinge half (Group II); certificated in any category. \n\n\tCompliance: Required as indicated, unless previously accomplished. \n\n\tTo prevent the loss of the LH or RH MLG outboard door, accomplish the following: \n\n\t(a)\tFor Group I airplanes: Within 30 days after February 11, 1991 (the effective date of Amendment 39-6869, AD 91-03-07), and thereafter at intervals not to exceed one year, accomplish the following in accordance with McDonnell Douglas Alert Service Bulletin A32-244, dated November 20, 1990, for both the LH and RH MLG outboard door assemblies: \n\n\t\t(1)\tInspect the MLG door for delamination; and \n\n\t\t(2)\tInspect the MLG door linkages and their attachments for corrosion, pitting, wear, and general conditions; and \n\n\t\t(3)\tInspect the MLG door hinge lobes on both the wing-mounted hinge half and door-mounted hinge half for cracks and corrosion; and \n\n\t\t(4)\tInspect the hinge halves on articulating doors for cracks and corrosion. \n\n\t(b)\tFor Group II airplanes: Within 50 days after the effective date of this AD, and thereafter at intervals not to exceed one year, accomplish the following in accordance with McDonnell Douglas Alert Service Bulletin A32-244, dated November 20, 1990, for both the LH and RH MLG outboard door assemblies: \n\n\t\t(1)\tInspect the MLG door for delamination; and \n\n\t\t(2)\tInspect the MLG door linkages and their attachments for corrosion, pitting, wear, and general conditions; and \n\n\t\t(3)\tInspect the MLG door hinge lobes on both the wing-mounted hinge half and door-mounted hinge half for cracks and corrosion; and \n\n\t\t(4)\tInspect the hinge halves on articulating doors for cracksand corrosion. \n\n\t(c)\tFor Group I and II airplanes: Within 18 months after the effective date of this AD, measure the aluminum hinge lobes, if bushed, for minimum wall thickness of .055 inch or greater, in accordance with McDonnell Douglas Alert Service Bulletin A32-244, dated November 20, 1990. \n\n\t(d)\tIf discrepancies are found as a result of the inspections required by paragraph (a), (b), or (c) of this AD, prior to further flight, repair in a manner approved by the Manager of the Los Angeles Aircraft Certification Office (ACO). \n\n\t(e)\tAn alternative method of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. \n\n\tNOTE: The request should be forwarded through an FAA Principal Maintenance Inspector, who may concur or comment and then send it to the Manager, Los Angeles ACO. \n\n\t(f)\tSpecial flight permitsmay be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD. \n\n\t(g)\tThe inspection, replacement, and repair requirements shall be done in accordance with McDonnell Douglas Alert Service Bulletin A32-244, dated November 20, 1990. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from McDonnell Douglas Corporation, P. O. Box 1771, Long Beach, California 90846-0001, Attention: Business Unit Manager, Technical Publications, C1-HDR (54-60). Copies may be inspected at the FAA, Northwest Mountain Region, Transport Airplane Directorate, 1601 Lind Avenue S.W., Renton, Washington; or at the Los Angeles Aircraft Certification Office, 3229 East Spring Street, Long Beach, California; or at the Office of the Federal Register, 1100 L Street N.W., Room 8401, Washington, D.C. \n\n\tAirworthiness Directive 91-22-07 supersedes AD 91-03-07, Amendment 39-6869. \n\n\tThis amendment (39-8067, AD 91-22-07) becomes effective on December 3, 1991.

Related safety bulletins advice on the same designs, not orders

2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565
2014-11-24NM-15-03 · Flight Controls
2008-09-03NM-08-43 · Cabin Equipment/Furnishings - Seats
2006-07-27NM-06-57 · Reports of damage to airplanes and to property on the ground caused by blue or clear ice falling from airplanes.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/91-22-07.json · aircraft systems.