The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

89-25-03: Inspect Window Belt Panels

FAA order 89-25-03 is an airworthiness directive in force since December 18, 1989. The FAA's subject line: Inspect Window Belt Panels. It names Douglas DC-9, Mcdonnell Douglas DC-9: about 100 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: airframe structure.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
DC-9-11, DC-9-12, DC-9-13, DC-9-14, DC-9-15, DC-9-15F, DC-9-21, DC-9-31, DC-9-32, DC-9-32 (VC-9C), DC-9-32F, DC-9-32F (C-9A), DC-9-32F (C-9B), DC-9-33F, DC-9-34, DC-9-34F, DC-9-41, DC-9-51, DC-9-81 (MD-81), DC-9-82 (MD-82)
On this site
Douglas DC-9 7 registered
Mcdonnell Douglas DC-9 93 registered

Dates and paperwork

In force since
December 18, 1989
Docket
89-NM-228-AD
Status
Current
The FAA's document
Read the order on the FAA's site

The order itself the regulatory text, as published

Show the full text (4,715 characters)
89-25-03 MCDONNELL DOUGLAS: Amendment 39-6408. Docket No. 89-NM-228-AD. \n\n\tApplicability: Model DC-9-10, -20, -30, -40, -50, -81, -82 and C-9 (Military) series airplanes, certificated in any category. \n\n\tCompliance: Required as indicated, unless previously accomplished. \n\n\tTo prevent crack propagation, which could result in rapid cabin depressurization, accomplish the following: \n\n\tA.\tFor airplanes fuselage numbers 1 through 950: Prior to the occurrence of the latest of the compliance times set forth below, inspect the left- and right-hand window belt panels and adjacent structure for cracks using eddy current methods, in accordance with McDonnell Douglas Alert Service Bulletin (ASB) A53-142, Revision 8, dated October 25, 1989 (hereinafter referred to as ASB 53-142): \n\n\t\t1.\tPrior to the accumulation of 30,000 or more landings; or \n\n\t\t2.\tWithin 2,500 landings since the last inspection in accordance with Amendment 39-5136, AD 85-19-02; or \n\n\t\t3.\tWithin 500 landingsafter the effective date of this AD. \n\n\tB.\tFor airplanes, fuselage numbers 951 through 1157: Prior to the occurrence of the latest of the compliance times set forth below, inspect the left- and right-hand window belt panels and adjacent structure for cracks using eddy current methods, in accordance with McDonnell Douglas ASB A53-142: \n\n\t\t1.\tPrior to the accumulation of 30,000 or more landings; or \n\n\t\t2.\tWithin 10,000 landings since the last inspection in accordance with Amendment 39-5136, AD 85-19-02; or \n\n\t\t3.\tWithin 500 landings after the effective date of this AD. \n\n\tC.\tRepeat the inspections required by paragraph A. of this AD at intervals not to exceed 800 landings, until such time as the preventive modification is installed in accordance with McDonnell Douglas Service Bulletin 53-142, dated June 30, 1983. \n\n\tD.\tRepeat the inspections required by paragraph B. of this AD at intervals not to exceed 20,000 landings, until such time as preventive modification is installedin accordance with McDonnell Douglas Service Bulletin 53-142, dated June 30, 1983. \n\n\tE.\tCredit may be given for inspections and repairs already accomplished in accordance with earlier versions of the McDonnell Douglas ASB A53-142. \n\n\tF.\tIf any fuselage skin cracks are found, accomplish the procedures described in paragraphs F.1., F.2., or F.3., below: \n\n\t\t1.\tBefore further flight, repair fuselage skin cracks in accordance with Option 2 described in ASB A53-142; or \n\n\t\t2.\tBefore further flight, repair fuselage skin cracks in accordance with McDonnell Douglas DC-9 Drawing J060131. Repairs of fuselage skin cracks accomplished in accordance with Drawing J060131 must be visually inspected at intervals not to exceed 2,000 landings, and must be replaced by repairs accomplished in accordance with McDonnell Douglas Drawing J060109 within 4,000 landings. After accomplishment of repairs in accordance with Drawing J060109, inspect the unrepaired areas of the airplane in accordance withthe requirements of paragraphs C., above, for fuselages 1 through 950, or paragraph D., above, for fuselages 951 through 1157 or \n\n\t\t3.\tBefore further flight, install a placard in plain view of the pilot reading "Pressurized Flight Prohibited," and accomplish either paragraph F.1. or F.2., above, within 4,000 landings. \n\n\tG.\tSpecial flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes unpressurized to a base to comply with the requirements of this AD. \n\n\tH.\tAn alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region. \n\n\tNOTE: The request should be forwarded through an FAA Principal Maintenance Inspector (PMI), who will either concur or comment, and then send it to the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region. \n\n\tAll persons affected by this directive who have not already received the appropriate service information from the manufacturer may obtain copies upon request to McDonnell Douglas Corporation, 3855 Lakewood Boulevard, Long Beach, California 90846. This information may be examined at the FAA, Northwest Mountain Region, Transport Airplane Directorate, 17900 Pacific Highway South, Seattle, Washington, or the Los Angeles Aircraft Certification Office, 3229 East Spring Street, Long Beach, California. \n\n\tThis AD supersedes Amendment 39-5136, AD 85-19-02, which became effective on October 12, 1985. \n\n\tThis amendment (39-6408, AD 89-25-03) becomes effective on December 18, 1989.

Related safety bulletins advice on the same designs, not orders

2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565
2014-11-24NM-15-03 · Flight Controls
2008-09-03NM-08-43 · Cabin Equipment/Furnishings - Seats
2006-07-27NM-06-57 · Reports of damage to airplanes and to property on the ground caused by blue or clear ice falling from airplanes.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/89-25-03.json · aircraft systems.