2026-22-05: Wing

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2026-22-05 The Boeing Company: Amendment 39-23507; Docket No. FAA-2026-1322; Project Identifier AD-2025-01665-T. (a) Effective Date This airworthiness directive (AD) is effective December 7, 2026. (b) Affected ADs None. (c) Applicability This AD applies to The Boeing Company Model 787-8, 787-9, and 787-10 airplanes, certificated in any category, as identified in Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025. (d) Subject Air Transport Association (ATA) of America Code 57, Wing. (e) Unsafe Condition This AD was prompted by a report that, during production, certain sealant installations within the center wing fuel tank volume did not receive required visual and adhesion inspections. The FAA is issuing this AD to address the potential for sealant defects. The unsafe condition, if not addressed, could result in development of an ignition source within the fuel tank volume and a risk of a fuel tank explosion during a lightning strike event. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Except as specified by paragraph (h) of this AD: At the applicable times specified in the "Compliance" paragraph of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, do all applicable actions identified in, and in accordance with, the Accomplishment Instructions of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025. Note 1 to paragraph (g): Guidance for accomplishing the actions required by this AD can be found in Boeing Alert Service Bulletin B787-81205-SB570053-00, Issue 001, dated November 5, 2025, which is referred to in Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025. (h) Exceptions to Requirements Bulletin Specifications (1) Where the Compliance Time column of the table in the "Compliance" paragraph of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, refers to the Issue 001 date of Requirements Bulletin B787-81205-SB570053-00 RB, this AD requires using the effective date of this AD. (2) Where Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, specifies contacting Boeing for repair instructions, this AD requires doing the repair using a method approved in accordance with the procedures specified in paragraph (i) of this AD. For sealant installation repairs: Complying with Airworthiness Limitations (AWLs) Nos. 28-AWL-83, 28-AWL-120, 28-AWL-121, 28-AWL-123, 28-AWL-124, and 28-AWL-125, as applicable, in Section D, "Summary List of AWLs," of Boeing 787 Special Compliance Items/Airworthiness Limitations, D011Z009-03-04, dated August 2018, is an acceptable repair. (i) Alternative Methods of Compliance (AMOCs) (1) The Manager, AIR-520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (j)(1) of this AD. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, AIR-520, Continued Operational Safety Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD. (j) Additional Information (1) For more information about this AD, contact Tak Kobayashi, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3553; email: [email protected]. (2) Material identified in this AD that is not incorporated by reference is available at the address specified in paragraph (k)(3) of this AD. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025. (ii) Section D, "Summary List of AWLs," of Boeing 787 Special Compliance Items/Airworthiness Limitations, D011Z009-03-04, dated August 2018. (3) For Boeing material identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740-5600; telephone 562-797-1717; website myboeingfleet.com. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email [email protected]. Issued on October 26, 2026. Brian Knaup, Acting Deputy Director, Integrated Certificate Management Division, Aircraft Certification Service. [FR Doc. 2026-22318 Filed 10-30-26; 8:45 am]BILLING CODE 4910-13-P