Show the full text (5,509 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2026-10-07 Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.): Amendment 39-23347; Docket No. FAA-2025-2543; Project Identifier MCAI-2025-00215-T. (a) Effective Date This airworthiness directive (AD) is effective July 1, 2026. (b) Affected ADs None. (c) Applicability This AD applies to Airbus Canada Limited Partnership (Type Certificate previously held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Model BD-500-1A10 and BD-500-1A11 airplanes, certificated in any category, as identified in Transport Canada AD CF-2025-09, dated February 24, 2025 (Transport Canada AD CF-2025-09). (d) Subject Air Transport Association (ATA) of America Code 57, Wings. (e) Unsafe Condition This AD was prompted by the discovery that titanium fasteners had been incorrectly installed in the butt strap at the outer wing box lower skin to center wing box interface in lieu of the correct nickel alloy fasteners. The FAA is issuing this AD to address the use of titanium fasteners. The unsafe condition, if not addressed, could result in a reduction in joint strength, potential damage to and loss of principal structure and fatigue critical structure, and the risk of a fuel leak if the fastener fails and falls free from the joint. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2025-09. (h) Exceptions to Transport Canada AD CF-2025-09 (1) Where Transport Canada AD CF-2025-09 refers to its effective date, this AD requires using the effective date of this AD. (2) Where Transport Canada AD CF-2025-09 refers to "10 000 flight cycles", this AD requires replacing that text with "10,000 total flight cycles". (3) Where Transport Canada AD CF-2025-09 specifies to "contact ACLP for an approved disposition in accordance with the ACLP SB procedure and perform the ACLP disposition instructions", this AD requires replacing that text with "contact ACLP for an approved disposition and perform the ACLP disposition instructions". (i) No Reporting Requirement Although the material referenced in Transport Canada AD CF-2025-09 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (j) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, AIR-520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (k) of this AD and email to: AMOC@faa.gov . Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, AIR-520, Continued Operational Safety Branch, FAA; or Transport Canada; or Airbus Canada Limited Partnership's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature. (k) Additional Information For more information about this AD, contact Bill Ashforth, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3520; email: bill.ashforth@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Transport Canada AD CF-2025-09, dated February 24, 2025. (ii) [Reserved] (3) For Transport Canada material identified in this AD, contact Transport Canada, Transport Canada National Aircraft Certification, 159 Cleopatra Drive, Nepean, Ontario K1A 0N5, Canada; telephone 888-663-3639; email TC.AirworthinessDirectives-Consignesdenavigabilite.TC@tc.gc.ca. You may find this material on the Transport Canada website at tc.canada.ca/en/aviation. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov. Issued on May 11, 2026. Brian Knaup, Acting Deputy Director, Integrated Certificate Management Division, Aircraft Certification Service. [FR Doc. 2026-10486 Filed 5-26-26; 8:45 am]BILLING CODE 4910-13-P