2023-07-02: Equipment/furnishings

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by: a. Removing Airworthiness Directive (AD) 2022-03-12, Amendment 39-21929 (87 FR 8169, February 14, 2022); and b. Adding the following new AD: 2023-07-02 Airbus SAS: Amendment 39-22404; Docket No. FAA-2023-0028; Project Identifier MCAI-2022-01164-T. (a) Effective Date This airworthiness directive (AD) is effective May 30, 2023. (b) Affected ADs This AD replaces AD 2022-03-12, Amendment 39-21929 (87 FR 8169, February 14, 2022) (AD 2022-03-12). (c) Applicability This AD applies to all Airbus SAS airplanes, certificated in any category, as identified in paragraphs (c)(1) through (8) of this AD. (1) Model A330-201, -202, -203, -223, and -243 airplanes. (2) Model A330-301, -302, -303, -321, -322, -323, -341, -342, and -343 airplanes. (3) Model A330-841 airplanes. (4) Model A330-941 airplanes. (5) Model A340-211, -212, and -213 airplanes. (6) Model A340-311, -312, and -313 airplanes. (7) Model A340-541 airplanes. (8) Model A340-642 airplanes. (d) Subject Air Transport Association (ATA) of America Code 25, Equipment/furnishings. (e) Unsafe Condition This AD was prompted by reports that the instructions on the doghouse door lock placard are unclear and incomplete, and by a determination that additional parts need to be modified. The FAA is issuing this AD to address possible incorrect operation of the doghouse door lock due to unclear and incomplete handling instructions on the door placard installed near the lock. The unsafe condition, if not addressed, could result in failure of the latch, which could block the door in the closed position and prevent access to the emergency equipment inside the doghouse. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2022-0179, dated August 26, 2022 (EASA AD 2022-0179). (h) Exceptions to EASA AD 2022-0179 (1) Where EASA AD 2022-0179 refers to June 18, 2021 (the effective date of EASA AD 2021-0136), this AD requires using March 21, 2022 (the effective date of AD 2022-03-12). (2) Where EASA AD 2022-0179 refers to its effective date, this AD requires using the effective date of this AD. (3) Although EASA AD 2022-0179 specifies to "remove the placard and install an improved handling instructions placard on each affected part," this AD requires replacing the placard on each affected part with an improved handling instructions placard. (4) This AD does not adopt the "Remarks" section of EASA AD 2022-0179. (i) Additional FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (3) Required for Compliance (RC): Except as required by paragraph (i)(2) of this AD, if any service information contains procedures or tests that are identified as RC, those procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC. (j) Additional Information For more information about this AD, contact Vladimir Ulyanov, Aerospace Engineer, Large Aircraft Section, FAA, International Validation Branch, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3229; email [email protected]. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2022-0179, dated August 26, 2022. (ii) [Reserved] (3) For EASA AD 2022-0179, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email [email protected]; website easa.europa.eu. You may find this EASA AD on the EASA website at ad.easa.europa.eu. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email [email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on March 30, 2023. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-08529 Filed 4-21-23; 8:45 am]BILLING CODE 4910-13-P