1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2022-24-02 Airbus SAS: Amendment 39-22242; Docket No. FAA-2022-0890; Project Identifier MCAI-2022-00391-T. (a) Effective Date This airworthiness directive (AD) is effective January 9, 2023. (b) Affected ADs None. (c) Applicability This AD applies to Airbus SAS Model A300 F4-605R and F4-622R airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2022-0048, dated March 18, 2022 (EASA AD 2022-0048). (d) Subject Air Transport Association (ATA) of America Code 52, Doors. (e) Unsafe Condition This AD was prompted by a determination that the forward cargo door compartment between frames 21 through 25 forks is susceptible to widespread fatigue damage (WFD). The FAA is issuing this AD to address this condition, which if not corrected, could result in reduced structural integrity of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2022-0048. (h) Exceptions to EASA AD 2022-0048 (1) Where the service information referenced in EASA AD 2022-0048 specifies installing a label (placard) having part number (P/N) ABS2127B01 on the forward cargo compartment door, this AD allows installing an equivalent label provided the label contains the same information as the label having P/N ABS2127B01. (2) The "Remarks" section of EASA AD 2022-0048 does not apply to this AD. (i) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to:
[email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Additional Information For more information about this AD, contact Dan Rodina, Aerospace Engineer, Large Aircraft Section, FAA, International Validation Branch, 2200 South 216th St., Des Moines, WA 98198; telephone 206-231-3225; email
[email protected]. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2022-0048, dated March 18, 2022. (ii) [Reserved] (3) For EASA AD 2022-0048, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email
[email protected]; website easa.europa.eu. You may find this EASA AD on the EASA website at ad.easa.europa.eu. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on November 9, 2022. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2022-26355 Filed 12-2-22; 8:45 am]BILLING CODE 4910-13-P