eFlight
FAA orders · airworthiness directive · current

2020-11-11: Fuel

FAA order 2020-11-11 is an airworthiness directive in force since June 18, 2020. The FAA's subject line: Fuel. It names Boeing 777: about 359 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: fuel system.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
777-200 Series, 777-200LR Series, 777-300 Series, 777-300ER Series, 777F Series
On this site
Boeing 777 359 registered

Dates and paperwork

In force since
June 18, 2020
Published
June 3, 2020 (signed May 28, 2020)
Docket
FAA-2020-0461
Replaced by
2022-23-11
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This AD requires a repetitive check of the fuel quantity indicating system (FQIS) fuel quantity calculation for the center wing tank (CWT) fuel quantity, developing a process to provide documentation to the flight crew that this check was done, and revising the existing airplane flight manual (AFM) to incorporate verification procedures and flight crew awareness. This AD was prompted by reports of discrepancies between the FQIS fuel quantity and the refueling truck uploaded fuel amount, followed by certain engine-indicating and crew-alerting system (EICAS) messages. The FAA is issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (6,378 characters)
Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2020-11-11 The Boeing Company: Amendment 39-19915; Docket No. FAA- 2020-0461; Product Identifier 2020-NM-065-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective June 18, 2020. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to The Boeing Company Model 777-200, -200LR, - 300, -300ER, and 777F series airplanes, certificated in any category, equipped with a Center Wing Tank (CWT) having a capacity of 26,100 U.S. gallons or greater. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 28, Fuel. \n\n(e) Unsafe Condition \n\n\n\tThe FAA is issuing this AD to address discrepancies in the CWT fuel quantity indicating system (FQIS) fuel quantity and the refueling truck uploaded fuel amount, which could result in an airplane dispatched with insufficient fuel loaded in the CWT and with the flight crew unaware of the insufficient fuel prior to departure. This condition, coupled with continued flight to the destination airport after receiving engine-indicating and crew- alerting system (EICAS) messages while en route to the destination, could result in fuel exhaustion and subsequent power loss of all engines. Thereby, resulting in the inability to land at the destination airport or at a diversion airport, possibly leading to uncontrolled flight into terrain. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) CWT Fuel Quantity Check--''Refueling Station Door Cycling Procedure'' \n\n\n\tWithin 30 days after the effective date of this AD: Check the fuel quantity of the CWT by doing the ''Refueling Station Door Cycling Procedure'' as specified in paragraphs (g)(1) through (6) of this AD. Thereafter, check the fuel quantity of the CWT as specified in paragraphs (g)(1) through (6) of this AD before further flight after any center tank fueling (adding or removing fuel). \n\t(1) Get access to the refueling station door and integrated refuel panel on the left wing. \n\t(2) Close and latch the refueling station door on the left wing for a minimum of five (5) seconds. If installed, make sure the right wing refueling station door is closed. \n\t(3) Re-open the refueling station door and wait for the fuel quantity display to reset. \n\t(4) Make sure that the center or total fuel tank quantities still remain within fuel load sheet requirements. If the fuel quantity is incorrect then accomplish actions specified in paragraphs (g)(4)(i) and (ii) of this AD. \n\t(i) Adjust fuel loading as applicable for fuel upload parameters. Refer to operator's refuel procedures for adjusting the fuel load. \n\t(ii) Repeat the ''Refueling Station Door Cycling Procedure,'' starting at paragraph (g)(2) of this AD. \n\t(5) Close the refueling station door. \n\t(6) Notify the operator after the ''Refueling Station Door Cycling Procedure'' has been done, and correct fuel load verified. \n\n(h) Process To Provide Documentation to the Flight Crew \n\n\n\tWithin 30 days after the effective date of this AD, submit a process to the FAA (Flight Standards) for approval that describes at the end of the fueling process and before each flight how documentation is provided to the flight crew that the CWT fuel quantity check using the ''Refueling Station Door Cycling Procedure'' specified in paragraph (g) of this AD was done. \n\n(i) Airplane Flight Manual (AFM) Revision Requiring Flight Crew Verification \n\n\n\t(1) Within 30 days after the effective date of this AD: Revise the ''Certificate Limitations: Fuel Quantity Indication System \n\n((Page 34093))(FQIS)'' section of the operator's existing AFM by incorporating the information specified in figure 1 to paragraph (i)(1) of this AD. (GRAPHIC) (TIFF OMITTED) TR03JN20.013 \n\n\n\t(2) Within 30 days after the effective date of this AD: Revise the ''Normal Procedures: Fuel Quantity Indication System (FQIS)-- Refueling Station Door Cycling Procedure'' section of the operator's existing AFM by incorporating the information specified in figure 2 to paragraph (i)(2) of this AD. BILLING CODE 4910-13-P \n\n((Page 34094)) \n\n(GRAPHIC) (TIFF OMITTED) TR03JN20.014 \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Seattle ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Kevin Nguyen, Aerospace Engineer, Propulsion Section, FAA, Seattle ACO Branch, 2200 South 216th St., Des Moines, WA 98198; phone and fax: 206-231- 3555; email: [email protected]. \n\n(l) Material Incorporated by Reference \n\n\n\tNone. \n\n\n\tIssued on May 28, 2020. Lance T. Gant, Director, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2020-11993 Filed 5-29-20; 4:15 pm) \n\tBILLING CODE 4910-13-C

Related safety bulletins advice on the same designs, not orders

2022-05-17AIR-22-09R1 · AUTOPILOT FLIGHT DIRECTOR SYSTEM: ALT HOLD Engaged on Takeoff on Boeing Model 777/787 common fleets.
2022-04-12AIR-22-09 · AUTOPILOT FLIGHT DIRECTOR SYSTEM: ALT HOLD Engaged on Takeoff on Boeing Model 777/787 common fleets.
2020-11-16AIR-20-19 · Flight Management Computing Software System
2020-06-11NM-20-11 · Autopilot System
2020-04-16NM-20-07 · Navigation - Glideslope System

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 20, 2026. Connections as data: /graph/directive/2020-11-11.json · aircraft systems.

Aircraft

By kindModelsMakersEnginesFleetsWhat changed

Fly

Plan a flightAirportsLive mapRoutes and flightsFuels

Training and work

TrainingFlight schoolsGround schoolsPilot examinersMedical examinersJobs

Companies

DirectoryCharter operatorsFBOsRepair stationsClaim your listing

Safety and data

AccidentsRecords checkAnalyticsSAFxCHANGEThe graphAbout

Colours follow your device's light or dark setting.