eFlight
FAA orders · airworthiness directive · current

2019-23-12: Wings

FAA order 2019-23-12 is an airworthiness directive in force since January 13, 2020. The FAA's subject line: Wings. It names Boeing 737: about 2,908 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: fuel system.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
737-300 Series, 737-400 Series, 737-500 Series
On this site
Boeing 737 2,908 registered

Dates and paperwork

In force since
January 13, 2020
Published
December 9, 2019 (signed November 18, 2019)
Docket
FAA-2019-0440
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-300, -400, and -500 series airplanes. This AD was prompted by fuel system reviews conducted by the manufacturer. This AD requires applying sealant to the fasteners in the fuel tanks, replacing wire bundle clamps external to the fuel tanks, and installing Teflon sleeving under the clamps. The FAA is issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (6,589 characters)
Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2019-23-12 The Boeing Company: Amendment 39-19806; Docket No. FAA- 2019-0440; Product Identifier 2019-NM-032-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective January 13, 2020. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\t(1) This AD applies to all The Boeing Company Model 737-300, - 400, and -500 series airplanes, certificated in any category. \n\t(2) Installation of Supplemental Type Certificate (STC) ST01219SE does not affect the ability to accomplish the actions required by this AD. Therefore, for airplanes on which STC ST01219SEis installed, a ''change in product'' alternative method of compliance (AMOC) approval request is not necessary to comply with the requirements of 14 CFR 39.17. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 57, Wings. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by fuel system reviews conducted by the manufacturer to ensure their fuel tank systems can prevent potential ignition sources. The FAA is issuing this AD to address potential ignition sources inside the fuel tank, which, in combination with flammable vapors, could result in a fuel tank fire or explosion, and consequent loss of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Apply Sealant, Replace Clamps, and Install Teflon Sleeving \n\n\n\tExcept as specified in paragraph (h) of this AD: At the applicable times specified in paragraph 1.E., ''Compliance,'' of the Accomplishment Instructions of Boeing Alert Service Bulletin 737- 57A1321, dated February 8, 2019, do all applicable actions identified as ''RC'' (required for compliance) in, and in accordance with, the Accomplishment Instructions of Boeing Alert Service Bulletin 737-57A1321, dated February 8, 2019. \n\n(h) Exceptions to Service Information Specifications \n\n\n\t(1) For purposes of determining compliance with the requirements of this AD: Where Boeing Alert Service Bulletin 737-57A1321, dated February 8, 2019, uses the phrase ''the original issue date of this service bulletin,'' this AD requires using ''the effective date of this AD.'' \n\t(2) Where Boeing Alert Service Bulletin 737-57A1321, dated February 8, 2019, specifies contacting Boeing: This AD requires doing actions using a method approved in accordance with the procedures specified in paragraph (i) of this AD. \n\n(i) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Los Angeles ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using theprocedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, Los Angeles ACO Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\t(4) Except as specified by paragraph (h)(2) of this AD: For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (i)(4)(i) and (ii) of this AD apply. \n\t(i) The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. If a step or substep is labeled ''RC Exempt,'' then the RC requirement is removed from that step or substep. An AMOC is required for any deviations to RC steps, including substeps and identified figures. \n\t(ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition. \n\n(j) Related Information \n\n\n\tFor more information about this AD, contact Serj Harutunian, Aerospace Engineer, Propulsion Section, FAA, Los Angeles ACO Branch, 3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 562-627- 5254; fax: 562-627-5210; email: [email protected]. \n\n(k) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Alert Service Bulletin 737-57A1321, dated February 8, 2019. \n\t(ii) (Reserved) \n\t(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740- 5600; telephone 562-797-1717; internet https://www.myboeingfleet.com. \n\t(4) You may view this service information at the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email [email protected], or go to: https:// \n\n((Page 67179)) \n\nwww.archives.gov/federal-register/cfr/ibr-locations.html.

Related safety bulletins advice on the same designs, not orders

2026-10-232026-18 · NOSE/TAIL LANDING GEAR, Installation of AeroControlex STC ST01255CH may allow water to leak and freeze on...
2026-10-032026-17 · VNAV Approach Disconnect Following Missed Approach, Anomaly on Airplanes with FMC U14.0/14.1
2026-01-082026-01 · PITOT/STATIC ANTI-ICE SYSTEM
2025-09-082025-08 · INDICATING/RECORDING SYSTEM, Erroneous Illumination of Cabin Altitude Warning Lights in High Altitude Landing Mode
2021-08-03AIR-21-12 · Thrust Reversers

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 20, 2026. Connections as data: /graph/directive/2019-23-12.json · aircraft systems.

Aircraft

By kindModelsMakersEnginesFleetsWhat changed

Fly

Plan a flightAirportsLive mapRoutes and flightsFuels

Training and work

TrainingFlight schoolsGround schoolsPilot examinersMedical examinersJobs

Companies

DirectoryCharter operatorsFBOsRepair stationsClaim your listing

Safety and data

AccidentsRecords checkAnalyticsSAFxCHANGEThe graphAbout

Colours follow your device's light or dark setting.