The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

2014-21-05: Fuselage

FAA order 2014-21-05 is an airworthiness directive in force since December 2, 2014. The FAA's subject line: Fuselage. It names Douglas DC-10, Mcdonnell Douglas DC-10, Mcdonnell Douglas MD-10: about 40 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: airframe structure.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
The Boeing Company
Models
DC-10-10, DC-10-10F, DC-10-30, DC-10-30F (KC-10A, KDC-10), DC-10-40, MD-10-10F, MD-10-30F
On this site
Douglas DC-10 8 registered
Mcdonnell Douglas DC-10 17 registered
Mcdonnell Douglas MD-10 15 registered

Dates and paperwork

In force since
December 2, 2014
Published
October 28, 2014 (signed October 13, 2014)
Docket
FAA-2014-0423
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model DC-10-10, DC-10-10F, DC-10-30, DC-10-30F (KC- 10A and KDC-10), DC-10-40, MD-10-10F, and MD-10-30F airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that the forward cargo compartment frames are subject to widespread fatigue damage (WFD). This AD requires an inspection of the attachment holes at the forward cargo compartment frames and the cargo liner for cracking, and repair if necessary. This AD would also require installing new oversized fasteners in the forward cargo compartment frames. We are issuing this AD to prevent fatigue cracking of the forward cargo compartment frames, which could result in loss of the fail-safe structural integrity of the airplane.

The order itself the regulatory text, as published

Show the full text (5,282 characters)
Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2014-21-05 The Boeing Company: Amendment 39-17997 ; Docket No. FAA- 2014-0423; Directorate Identifier 2013-NM-233-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective December 2, 2014. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to The Boeing Company Model DC-10-10, DC-10-10F, DC-10-30, DC-10-30F (KC-10A and KDC-10), DC-10-40, MD-10-10F, and MD-10-30F airplanes, certificated in any category, as identified in Boeing Service Bulletin DC10-53-182, dated June 28, 2013. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA)of America Code 53, Fuselage. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by an evaluation by the design approval holder (DAH) indicating that the forward cargo compartment frames are subject to widespread fatigue damage (WFD). We are issuing this AD to prevent fatigue cracking of the forward cargo compartment frames, which could result in loss of the fail-safe structural integrity of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Inspection \n\n\n\tPrior to the accumulation of 30,000 total flight cycles, or within 72 months after the effective date of this AD, whichever occurs later: Do a high frequency eddy current inspection for cracking of the attachment holes at the forward cargo compartment frames and the cargo liner, in accordance with the Accomplishment Instructions of Boeing Service Bulletin DC10-53-182, dated June 28, 2013. If any crack is found, before further flight, repair using a method approved in accordance with the procedures specified in paragraph (i) of this AD. \n\n(h) Installation of New Fasteners \n\n\n\tIf no cracking is found during the inspection required by paragraph (g) of this AD: Before further flight, install new oversized fasteners to attach the forward cargo liner to the forward cargo compartment frame, in accordance with the Accomplishment Instructions of Boeing Service Bulletin DC10-53-182, dated June 28, 2013. \n\n(i) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Los Angeles Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: [email protected]. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Los Angeles ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\n(j) Related Information \n\n\n\tFor more information about this AD, contact Nenita Odesa, Aerospace Engineer, Airframe Branch, ANM 120L, Los Angeles Aircraft Certification Office (ACO), FAA, 3960 Paramount Boulevard, Lakewood, CA 90712 4137; phone: 562-627-5234; fax: 562-627-5210; email: [email protected]. \n\n(k) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Service Bulletin DC10-53-182, dated June 28, 2013. \n\t(ii) Reserved. \n\t(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, CA 90846-0001; telephone 206-544-5000, extension 2; fax 206-766-5683; Internet https://www.myboeingfleet.com. \n\t(4) You may view this service information at FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA 98057-3356. For information on the availability of this material at the FAA, call 425-227-1221. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\n((Page 64084))

Related safety bulletins advice on the same designs, not orders

2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565
2014-11-24NM-15-03 · Flight Controls
2008-12-11NM-09-03 · Engine Fuel and Control - Implementing Fuel Tank System Airworthiness Limitations
2006-07-27NM-06-57 · Reports of damage to airplanes and to property on the ground caused by blue or clear ice falling from airplanes.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 6, 2026. Connections as data: /graph/directive/2014-21-05.json · aircraft systems.