2009-16-14: Forward entry door

2009-16-14 Boeing: Amendment 39-15987. Docket No. FAA-2008-1213; Directorate Identifier 2007-NM-092-AD. \n\nEffective Date \n\n\t(a) This AD becomes effective September 9, 2009. \n\nAffected ADs \n\n\t(b) This AD supersedes AD 2005-20-03. \n\nApplicability \n\n\t(c) This AD applies to Model 737-100, -200, -200C, -300, -400, and -500 series airplanes, certificated in any category; as identified in Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007. \n\nUnsafe Condition \n\n\t(d) This AD results from reports of fatigue cracks. We are issuing this AD to detect and correct fatigue cracking of the intercostals on the forward and aft sides of the forward entry door, which could result in loss of the forward entry door and rapid decompression of the airplane. \n\nCompliance \n\n\t(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. \n\nInitial Compliance Time \n\n\t(f) For all Model 737-100, -200, -200C, -300, -400, and -500 series airplanes: Before the accumulation of 15,000 total flight cycles, or within 4,500 flight cycles after November 1, 2005 (the effective date of AD 2005-20-03), whichever occurs later: Do the inspections required by paragraphs (h) and (i) of this AD. \n\t(g) For all Model 737-200C series airplanes: Before the accumulation of 15,000 total flight cycles, or within 4,500 flight cycles after the effective date of this AD, whichever occurs later: Do the inspection required by paragraph (j) of this AD. \n\nInitial Inspection for Passenger Configuration Airplanes \n\n\t(h) For Group 1 passenger airplanes identified in Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007: Perform a detailed inspection for cracking of the intercostal web, attachment clips, and stringer splice channels; and a high frequency eddy current inspection for cracking of the stringer splice channels located forward and aft of the forwardentry door; and do all applicable corrective actions before further flight; in accordance with Parts 1 and 2 of the Work Instructions of Boeing Special Attention Service Bulletin 737-53- 1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737- 53A1204, Revision 1, dated March 26, 2007. After the effective date of this AD, only Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007, may be used. \n\nInitial Inspection for Cargo Configuration Airplanes (Forward of the Forward Entry Door) \n\n\t(i) For Group 2 cargo airplanes identified in Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007: Perform a detailed inspection for cracking of the intercostal webs and attachment clips located forward of the forward entry door, and do all applicable corrective actions before further flight, in accordance with Part 3 of the Work Instructions of Boeing Special Attention Service Bulletin 737-53-1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007. After the effective date of this AD, only Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007, may be used. \n\nInitial Inspection for Cargo Configuration Airplanes (Aft of the Forward Entry Door) \n\n\t(j) For Group 2 cargo airplanes identified in Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007: Perform a detailed inspection for cracking of the intercostal webs and attachment clips located aft of the forward entry door, and do all applicable corrective actions before further flight, in accordance with Part 4 of the Work Instructions of Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007. \n\nRepeat Inspections \n\n\t(k) Repeat the inspections required by paragraphs (h), (i), and (j) of this AD thereafter at intervals not to exceed 6,000 flight cycles after the previous inspection, or within 3,000 flight cycles after the effective date of this AD, whichever occurs later. \n\nExceptions \n\n\t(l) Do the actions required by this AD by accomplishing all the applicable actions specified in the Accomplishment Instructions of Boeing Special Attention Service Bulletin 737-53-1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007; except as provided by paragraphs (l)(1) and (l)(2) of this AD. After the effective date of this AD, only Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007, may be used. \n\t(1) Where Boeing Special Attention Service Bulletin 737-53-1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007; specifies to contact Boeing for repair instructions: Before further flight, repair using a method approved in accordance with the procedures specified in paragraph (m) of this AD. \n\t(2) Where Boeing Special Attention Service Bulletin 737-53-1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007; specifies a compliance time relative to the date of a service bulletin, this AD requires compliance relative to the effective date of this AD. Where Boeing Special Attention Service Bulletin 737-53-1204, dated June 19, 2003; or Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007; specifies a compliance time relative to the date of the initial release of the service bulletin, this AD requires compliance relative to the effective date of AD 2005-20-03 (November 1, 2005). \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(m)(1) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Alan Pohl, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle ACO, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6450; fax (425) 917-6590. \n\t(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD, if it is approved by an Authorized Representative for the Boeing Commercial Airplanes Delegation Option Authorization Organization who has been authorized by the Manager, Seattle ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\t(4) AMOCs approved previously in accordance with AD 2005-20-03 are approved as AMOCs for the corresponding provisions of thisAD, provided the repetitive inspection intervals (if any) do not exceed 6,000 flight cycles. \n\t(5) AMOCs approved previously in accordance with AD 2005-20-03 are not approved as AMOCs for the provisions of paragraph (j) or (k) of this AD. \n\nMaterial Incorporated by Reference \n\n\t(n) You must use Boeing Alert Service Bulletin 737-53A1204, Revision 1, dated March 26, 2007; as applicable; to do the actions required by this AD, unless the AD specifies otherwise. \n\t(1) The Director of the Federal Register approved the incorporation by reference of Boeing Alert Service Bulletin 737- 53A1204, Revision 1, dated March 26, 2007, under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P. O. Box 3707, MC 2H-65, Seattle, Washington 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; e-mail [email protected]; Internet https://www.myboeingfleet.com. \n\t(3) You mayreview copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. \n\t(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http:// www.archives.gov/federal_register/code_of_federal_regulations/ ibr_locations.html.