2006-07-26: Outer wing boxes

2006-07-26 Aerospatiale: Amendment 39-14553. Docket No. FAA-2006- 23816; Directorate Identifier 2005-NM-247-AD. Effective Date (a) This AD becomes effective May 16, 2006. Affected ADs (b) None. Applicability (c) This AD applies to all Aerospatiale Model ATR42-200, -300, - 320, and -500 airplanes, certificated in any category. Unsafe Condition (d) This AD results from a report of cracking on the upper skin and ribs of the outer wing box on an in-service airplane. We are issuing this AD to detect and correct discrepancies (e.g., cracking, loose/sheared fasteners, distortion) of the upper skin and rib feet of the outer wing boxes, which could result in reduced structural integrity of the airplane. Compliance (e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. External Inspection and Repair (f) Before the accumulation of 4,000 total flight cycles, or within 3 months after the effective date of this AD, whichever is later: Do an external detailed inspection for discrepancies of the upper skin panels of the outer wing box on the left and right wing, from rib 24 to rib 29. Do the inspection in accordance with Part A of the Accomplishment Instructions of Avions de Transport Regional Service Bulletin ATR42-57-0064, dated December 16, 2004. (1) If any discrepancy is found: Before further flight, do the actions in paragraphs (f)(1)(i) and (f)(1)(ii) of this AD. (i) Repair using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the Direction G[eacute]n[eacute]rale de l'Aviation Civile (DGAC) (or its delegated agent). (ii) Do the internal inspection in accordance with paragraph (g) of this AD. (2) If no discrepancy is found: Within 4 months after doing the external detailed inspection, do the internal inspection in accordance with paragraph(g) of this AD. Note 1: For the purposes of this AD, a detailed inspection is: ``An intensive examination of a specific item, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at an intensity deemed appropriate. Inspection aids such as mirror, magnifying lenses, etc., may be necessary. Surface cleaning and elaborate procedures may be required.'' Internal Inspection and Repair (g) At the applicable time specified in paragraph (f)(1)(ii) or (f)(2) of this AD: Inspect for discrepancies of the rib feet from rib 24 to rib 29 using one of the inspection methods specified in paragraph (g)(1) or (g)(2) of this AD. Do the inspection in accordance with Part B of the Accomplishment Instructions of Avions de Transport Regional Service Bulletin ATR42-57-0064, dated December 16, 2004. If any discrepancy is found during any inspection required by this paragraph: Before further flight,repair using a method approved by either the Manager, International Branch, ANM-116, FAA, or the DGAC (or its delegated agent). (1) A borescopic inspection through access doors. (2) A detailed inspection after removing the leading edge of the wing. No Reporting (h) Although Avions de Transport Regional Service Bulletin ATR42-57-0064, dated December 16, 2004, specifies to submit certain information to the manufacturer, this AD does not include that requirement. Alternative Methods of Compliance (AMOCs) (i)(1) The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19. (2) Before using any AMOC approved in accordance with Sec. 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office. Related Information (j) French airworthiness directive F-2004-191, dated December 22, 2004, also addresses the subject of this AD. Material Incorporated by Reference (k) You must use Avions de Transport Regional Service Bulletin ATR42-57-0064, dated December 16, 2004, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact Aerospatiale, 316 Route de Bayonne, 31060 Toulouse, Cedex 03, France, for a copy of this service information. You may review copies at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street SW., Room PL-401, Nassif Building, Washington, DC; on the Internet at http://dms.dot.gov; or at the National Archives and Records Administration (NARA). For information on the availability of this material at the NARA, call (202) 741-6030, or go to http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html .