Show the full text (4,014 characters)
99-23-19 LEARJET, INC.: Amendment 39-11415. Docket 99-NM-15-AD.
Applicability: Model 31 and 31A airplanes, serial numbers 31-033, 31-105, 31-114, 31-126, and 31-150 through 31-161 inclusive; Model 35 and 35A airplanes, serial numbers 35-065, 35-242, 35-300, 35-323, 35-447, 35-622, and 35-670; and Model 60 airplanes, serial numbers 60-029, 60-050, 60-120 through 60-139 inclusive; certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent failure of the spoiler actuator, which could result in the spoiler panel floating and inducing an uncommanded roll of the airplane, accomplish the following:
Inspection and Replacement
(a) Within 150 flight hours after the effective date of this AD, perform a visual inspection to determine the serial number of the spoiler actuators, in accordance with Learjet Service Bulletins SB 31-27-19, dated December 14, 1998 (for Model 31 and 31A airplanes); SB 35-27-36, dated December 14, 1998 (for Model 35 and 35A airplanes); or SB 60-27-21, dated December 14, 1998 (for Model 60 airplanes); as applicable.
(1) If the serial number is not listed in the applicable service bulletin, no further action is required by this AD.
(2) If the serial number is listed in the applicable service bulletin, prior to further flight, replace the spoiler actuators with new actuators in accordance with the Accomplishment Instructions of the applicable service bulletin.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, Small Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.
Special Flight Permits
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
Incorporation by Reference
(d) The actions shall be done in accordance with Learjet Service Bulletin SB 31-27-19, dated December 14, 1998, Learjet Service Bulletin SB 35-27-36, dated December 14, 1998, or Learjet Service Bulletin SB 60-27-21, dated December 14, 1998, as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Learjet, Inc., One Learjet Way, Wichita, Kansas 67209-2942. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Small Airplane Directorate, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
(e) This amendment becomes effective on December 21, 1999.
