The U.S. aircraft register, updated daily
FAA orders · airworthiness directive · current

92-15-11: Compressor Delivery Air Line (P3) Filter Assembly

FAA order 92-15-11 is an airworthiness directive in force since August 17, 1992. The FAA's subject line: Compressor Delivery Air Line (P3) Filter Assembly. It names the Pratt & Whitney Canada PT6A-20, Pratt & Whitney Canada PT6A-20A, Pratt & Whitney Canada PT6A-21, Pratt & Whitney Canada PT6A-27, Pratt & Whitney Canada PT6A-28, Pratt & Whitney Canada PT6A-34, Pratt & Whitney Canada PT6A-36, Pratt & Whitney Canada PT6A-6, Pratt & Whitney Canada PT6A series engines: about 564 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: engine.

What it applies to as the FAA lists it

Kind of product
Engine
Makes
Pratt & Whitney Canada Corp.
Models
PT6A-20, PT6A-20A, PT6A-21, PT6A-27, PT6A-28, PT6A-34, PT6A-34B, PT6A-36, PT6A-6, PT6A-6/C20
Engine series
Pratt & Whitney Canada PT6A-20 23 aircraft
Pratt & Whitney Canada PT6A-20A 2 aircraft
Pratt & Whitney Canada PT6A-21 76 aircraft
Pratt & Whitney Canada PT6A-27 31 aircraft
Pratt & Whitney Canada PT6A-28 13 aircraft
Pratt & Whitney Canada PT6A-34 232 aircraft
Pratt & Whitney Canada PT6A-36 4 aircraft
Pratt & Whitney Canada PT6A-6 1 aircraft
Pratt & Whitney Canada PT6A series 182 aircraft

Dates and paperwork

In force since
August 17, 1992
Docket
91-ANE-06
Status
Current
The FAA's document
Read the order on the FAA's site

The order itself the regulatory text, as published

Show the full text (2,258 characters)
92-15-11 PRATT & WHITNEY CANADA: Amendment 39-8305. Docket No. 91-ANE-06. Applicability: Pratt & Whitney Canada (PWC) PT6A-6, PT6A-6/C20, PT6A-20, PT6A-20A, PT6A-21, PT6A-27, PT6A-28, PT6A-34, PT6A-34B, and PT6A-36 turboprop engines installed on Beech Aircraft Corporation Models 65-90, 65-A90, 65-A90-1, 65-A90-2, 65-A90-3, 65-A90-4, 99, 100, 99A, B90, C90, C90A, E90, H90, A99, A99A, B99, and C99 aircraft. Compliance: Required within the next 180 days after the effective date of this AD, unless accomplished previously. To prevent excessive engine acceleration time that could result in an aircraft's inability to safely perform the balked landing maneuver required by Federal Aviation Regulations (FAR) part 23, paragraphs 23.75(d), 23.77 and 23.143(a)(5), accomplish the following: (a) Perform a visual inspection to determine if a compressor delivery air line (P3) filter assembly has been installed on the engine. NOTE: The compressor delivery air line assembly may have been installed on the engine as original equipment, or may have been installed per any of the following PWC Service Bulletins: 1205, 1253, 1290, 1294, 1330, 1343, or 1378. (b) Remove from service, if installed, the P3 filter assembly. NOTE: The engine compressor delivery air line assembly can be returned to an approved configuration without a P3 filter. For information, refer to the applicable PWC Maintenance Manual and Parts Catalog. (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Engine Certification Office, FAA, Engine and Propeller Directorate. The request should be forwarded through an FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Engine Certification Office. NOTE: Information concerning the existence of approved alternative methods of compliance with this airworthiness directive, if any, may be obtained fromthe Engine Certification Office. (d) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished. (e) This amendment becomes effective on August 17, 1992.

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of October 5, 2026. Connections as data: /graph/directive/92-15-11.json · aircraft systems.