77-10-03: Fire Resistant Prop Feathering System
FAA order 77-10-03 is an airworthiness directive in force since June 16, 1977. The FAA's subject line: Fire Resistant Prop Feathering System. It names Lockheed 18: about 13 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: other and general.
What it applies to as the FAA lists it
- Kind of product
- Aircraft
- Makes
- Lockheed Aircraft Corporation
- Models
- 18
- On this site
- Lockheed 18 13 registered
Dates and paperwork
- In force since
- June 16, 1977
- Docket
- Unknown
- Status
- Current
- The FAA's document
- Read the order on the FAA's site
The order itself the regulatory text, as published
Show the full text (2,032 characters)
77-10-03 LOCKHEED: Amendment 39-2896. Applies to Lockheed Model 18 airplanes, certificated in all categories, using Hamilton standard propellers.
Compliance required by the first engine change after the effective date of this AD or October 1, 1977, whichever occurs earlier, unless previously accomplished in accordance with AD 55-15-03 as amended by Amendment 55-24 to Part 507.
To increase fire resistance integrity of the propeller feathering system against damage by a powerplant fire, all flexible hose components of propeller feathering lines forward of the firewall must be replaced with lines and fittings which will meet the fire resistance requirements of the hose assemblies specified in (a) through (g) herein. However, if the feathering lines in Zone I include a section of steel tubing, flexible hose assemblies located forward of the cylinders and connecting to the governor are not affected by this directive.
The following flexible hose assemblies are acceptable foruse in this application:
(a) Resistoflex SSFR-3800-10 hose assemblies.
(b) Aeroquip 680-10S hose assemblies with Aeroquip 304 protective sleeves over end fittings (Aeroquip Assembly P/N 304000).
(c) Aeroquip 309009 hose assemblies.
(d) Aeroquip 309009-8S hose assemblies (where feathering system requires this size).
(e) Aeroquip 634000-8 or -10, as applicable, hose assemblies.
(f) Aeroquip AE2460001 hose assemblies.
(g) Hose assemblies that fully comply with FAR 37.140 (TSO-C42) and have a pressure rating equal to or greater than that of the propeller feathering system installed on the airplane.
(h) Equivalent hose assemblies or other means of compliance may be used when approved by the Chief Aircraft Engineering Division, FAA Western Region.
Special flight permits may be issued in accordance with FAR's 21.97 and 21.199 to operate the airplane to a base for the accomplishment of this AD.
This supersedes AD 55-15-03, as amended by Amendment 55-24to Part 507.
This Amendment becomes effective June 16, 1977.
Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of October 5, 2026. Connections as data: /graph/directive/77-10-03.json · aircraft systems.