eFlight
FAA orders · airworthiness directive · current

2026-24-01: Hydraulic Pump, (Elect/Eng), Main

FAA order 2026-24-01 is an airworthiness directive in force since December 24, 2026. The FAA's subject line: Hydraulic Pump, (Elect/Eng), Main. It names Dornier DORNIER 228: about 11 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: heating, ice protection and utility systems.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
General Atomics AeroTec Systems GmbH
Models
Dornier 228-100, Dornier 228-101, Dornier 228-200, Dornier 228-201, Dornier 228-202, Dornier 228-212
On this site
Dornier DORNIER 228 11 registered

Dates and paperwork

In force since
December 24, 2026
Published
November 19, 2026 (signed November 17, 2026)
Docket
FAA-2025-5401
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

The FAA is adopting a new airworthiness directive (AD) for all General Atomics AeroTec Systems GmbH (General Atomics) Model Dornier 228-100, Dornier 228-101, Dornier 228-200, Dornier 228-201, Dornier 228-202, and Dornier 228-212 airplanes. This AD was prompted by reports of specific part-numbered hydraulic pump motors becoming severely damaged by excessive heat. This AD requires replacing the affected hydraulic pump motor with an improved design hydraulic pump motor. This AD also prohibits installing an affected hydraulic pump motor on any airplane. The FAA is issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (3,616 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2026-24-01 General Atomics AeroTec Systems GmbH (Type Certificate Previously Held by RUAG Aerospace Services GmbH): Amendment 39-23525; Docket No. FAA-2025-5401; Project Identifier MCAI-2025-01313-A. (a) Effective Date This airworthiness directive (AD) is effective December 24, 2026. (b) Affected ADs None. (c) Applicability This AD applies to all General Atomics AeroTec Systems GmbH (type certificate previously held by RUAG Aerospace Services GmbH) Model Dornier 228-100, Dornier 228-101, Dornier 228-200, Dornier 228-201, Dornier 228-202, and Dornier 228-212 airplanes, certificated in any category. (d) Subject Joint Aircraft System Component (JASC) Code 2913, Hydraulic Pump, (Elect/Eng), Main. (e) Unsafe Condition This AD was prompted by reports of several occurrences of hydraulic pump motors becoming severely damaged by excessive heat. The FAA is issuing this AD to prevent the overheating of the hydraulic pump motor. The unsafe condition, if not addressed, could result in an uncontained fire, possible injury to passengers and crew, and loss of control of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions For airplanes with an installed hydraulic pump motor having part number (P/N) 1259A, within 200 hours time-in-service of the hydraulic pump motor (for airplanes equipped with a hydraulic system elapsed time indicator), or 600 landings (for airplanes not equipped with a hydraulic system elapsed time indicator), as applicable, after the effective date of this AD, replace the hydraulic pump motor with a hydraulic pump motor having P/N A-752511A00B. Note to Paragraph (g): General Atomics AeroTec Dornier 228 Service Bulletin No. SB-228-360, Rev. 0, dated May 28, 2025, contains information related to this AD. (h) Installation Prohibition As of the effective date of this AD, do not install a hydraulic pump motor having P/N 1259A on any airplane. (i) Alternative Methods of Compliance (AMOCs) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (j)(1) of this AD and email to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (j) Additional Information (1) For more information about this AD, contact Doug Rudolph, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (816) 329-4059; email: [email protected]. (2) For material identified in this AD that is not incorporated by reference, contact General Atomics AeroTec Systems GmbH, Galileostraße 396, D-82131 Gauting, Germany; phone: +49 8153 302280; email: [email protected]; website: ga-ats.com/. (k) Material Incorporated by Reference None. Issued on November 17, 2026. Steven W. Thompson, Acting Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2026-23633 Filed 11-18-26; 8:45 am]BILLING CODE 4910-13-P

Related safety bulletins advice on the same designs, not orders

2008-05-23CE-08-25 · Propellers/Propulsion - Controlling

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 19, 2026. Connections as data: /graph/directive/2026-24-01.json · aircraft systems.

Aircraft

By kindModelsMakersEnginesFleetsWhat changed

Fly

Plan a flightAirportsLive mapRoutes and flightsFuels

Training and work

TrainingFlight schoolsGround schoolsPilot examinersMedical examinersJobs

Companies

DirectoryCharter operatorsFBOsRepair stationsClaim your listing

Safety and data

AccidentsRecords checkAnalyticsSAFxCHANGEThe graphAbout

Colours follow your device's light or dark setting.