2025-18-03: Oxygen

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by: a. Removing Airworthiness Directive (AD) 2023-25-09, Amendment 39-22636 (89 FR 242, January 3, 2024); and b. Adding the following new AD: 2025-18-03 Airbus SAS: Amendment 39-23130; Docket No. FAA-2025-1104; Project Identifier MCAI-2024-00622-T. (a) Effective Date This airworthiness directive (AD) is effective October 20, 2025. (b) Affected ADs This AD replaces AD 2023-25-09, Amendment 39-22636 (89 FR 242, January 3, 2024) (AD 2023-25-09). (c) Applicability This AD applies to all Airbus SAS airplanes identified in paragraphs (c)(1) through (6) of this AD, certificated in any category. (1) Model A318-111, -112, -121, and -122 airplanes. (2) Model A319-111, -112, -113, -114, -115, -131, -132, -133, -151N, -153N, and -171N airplanes. (3) Model A320-211, -212, -214, -216, -231, -232, -233, -251N, -252N, -253N, -271N, -272N, and -273N airplanes. (4) Model A321-111, -112, -131, -211, -212, -213, -231, -232, -251N, -251NX, -252N, -252NX, -253N, -253NX, -253NY, -271N, -271NX, -272N, and -272NX airplanes. (5) Model A330-201, -202, -203, -223, -223F, -243, -243F, -301, -302, -303, -321, -322, -323, -341, -342, -343, -841, and -941 airplanes. (6) Model A340-211, -212, -213, -311, -312, -313, -541, and -642 airplanes. (d) Subject Air Transport Association (ATA) of America Code 35, Oxygen. (e) Unsafe Condition This AD was prompted by a report that a production deficiency of some SafeLav gaseous oxygen container (SLGOC) batches was identified during production testing of newly manufactured oxygen containers, and by the determination that additional airplanes are affected by the unsafe condition. The FAA is issuing this AD to address missing heat treatment of the actuation pin of the SLGOC, which could cause its jamming, with consequent failure of oxygen flow activation. The unsafe condition, if not addressed, could result in lack of supplemental oxygen supply in case of decompression in the cabin/lavatory, possibly resulting in injury to lavatory occupants. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2024-0197, dated October 18, 2024 (EASA AD 2024-0197). (h) Exceptions to EASA AD 2024-0197 (1) Where EASA AD 2024-0197 refers to "22 May 2023 [the effective date of EASA AD 2023-0094]", this AD requires using "February 7, 2024 (the effective date of AD 2023-25-09)". (2) Where EASA AD 2024-0197 refers to its effective date, this AD requires using the effective date of this AD. (3) This AD does not adopt the "Remarks" section of EASA AD 2024-0197. (i) No Reporting Requirement Although the material referenced in EASA AD 2024-0197 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (j) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, AIR-520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (k) of this AD and email to: AMOC@faa.gov . Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, AIR-520, Continued Operational Safety Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (3) Required for Compliance (RC): Except as required by paragraphs (i) and (j)(2) of this AD, if any material referenced in EASA AD 2024-0197 contains paragraphs that are labeled as RC, the instructions in RC paragraphs, including subparagraphs under an RC paragraph, must be done to comply with this AD; any paragraphs, including subparagraphs under those paragraphs, that are not identified as RC are recommended. The instructions in paragraphs, including subparagraphs under those paragraphs, not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the instructions identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to instructions identified as RC require approval of an AMOC. (k) Additional Information For more information about this AD, contact Nicole S. Tsang, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3959; email: Nicole.S.Tsang@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2024-0197, dated October 18, 2024. (ii) [Reserved] (3) For EASA material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov . Issued on August 28, 2025. Peter A. White, Deputy Director, Integrated Certificate Management Division, Aircraft Certification Service. [FR Doc. 2025-17786 Filed 9-12-25; 8:45 am]BILLING CODE 4910-13-P