2024-22-06: Cabin Equipment/Furnishings

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by: a. Removing Airworthiness Directive 2023-21-06, Amendment 39-22578 (88 FR 76114, November 6, 2023; corrected December 7, 2023 (88 FR 85093)); and b. Adding the following new airworthiness directive: 2024-22-06 Embraer S.A.: Amendment 39-22877; Docket No. FAA-2024-2020; Project Identifier MCAI-2024-00303-A. (a) Effective Date This airworthiness directive (AD) is effective January 2, 2025. (b) Affected ADs This AD replaces AD 2023-21-06, Amendment 39-22578 (88 FR 76114, November 6, 2023; corrected December 7, 2023 (88 FR 85093)). (c) Applicability This AD applies to Embraer S.A. Model EMB-505 airplanes, certificated in any category, as identified in Agência Nacional de Aviação Civil (ANAC) AD 2023-05-03R02, effective May 17, 2024 (ANAC AD 2023-05-03R02). (d) Subject Joint Aircraft System Component (JASC) Code 2500, Cabin Equipment/Furnishings. (e) Unsafe Condition This AD was prompted by the analysis of certain monuments (the right-hand refreshment center and left-hand forward cabinet) that identified the need for installing structural reinforcements and replacing applicable floor support rivets. The FAA is issuing this AD to address the unsafe condition. The unsafe condition, if not addressed, could result in a monument not withstanding the loads expected for specific emergency landing conditions, which may cause the detachment of mass items and result in injuries to the airplane occupants. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, ANAC AD 2023-05-03R02. (h) Exceptions to ANAC AD 2023-05-03R02 (1) Where ANAC AD 2023-05-03R02 refers to its effective date, this AD requires using the effective date of this AD. (2) Where ANAC AD 2023-05-03R02 refers to Embraer Service Bulletin SB505-25-0046, Revision 03, as dated "May 6, 2024," replace that text with "May 7, 2024." (3) Where paragraph (b) of ANAC AD 2023-05-03R02 refers to "June 2, 2023, the effective date of AD 2023-05-03, original revision," replace that text with "December 11, 2023, the effective date of AD 2023-21-06." (4) Although the material referenced in ANAC AD 2023-05-03R02 allows the use of alternative or similar parts in place of the ones specified in the kits provided, this AD requires that alternative or similar parts be approved by the Manager, International Validation Branch, FAA; ANAC; or ANAC's authorized Designee. If approved by the ANAC Designee, the approval must include the Designee's authorized signature. (5) Where the material referenced in ANAC AD 2023-05-03R02 specifies to "discard" certain parts, replace that text with "remove from service." (6) This AD does not adopt paragraph (d)(1) of ANAC AD 2023-05-03R02. (i) No Reporting Requirement Although the material referenced in ANAC AD 2023-05-03R02 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (j) Alternative Methods of Compliance (AMOCs) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, mail it to the address identified in paragraph (k) of this AD or email to: AMOC@faa.gov. If mailing information, also submit information by email. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (k) Additional Information For more information about this AD, contact Jim Rutherford, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (816) 329-4165; email: jim.rutherford@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Agência Nacional de Aviação Civil (ANAC) AD 2023-05-03R02, effective May 17, 2024. (ii) [Reserved] (3) For ANAC material identified in this AD, contact ANAC, Continuing Airworthiness Technical Branch (GTAC), Rua Doutor Orlando Feirabend Filho, 230-Centro Empresarial Aquarius-Torre B-Andares 14 a 18, Parque Residencial Aquarius, CEP 12.246-190-São José dos Campos-SP, Brazil; phone: 55 (12) 3203-6600; email: pac@anac.gov.br; website: anac.gov.br/en/. You may find this material on the ANAC website at sistemas.anac.gov.br/certificacao/DA/DAE.asp. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 901 Locust, Kansas City, MO 64106. For information on the availability of this material at the FAA, call (817) 222-5110. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov . Issued on October 24, 2024. Victor Wicklund, Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2024-27709 Filed 11-26-24; 8:45 am]BILLING CODE 4910-13-P