2024-17-09: Cabin Equipment/Furnishings

1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2024-17-09 Embraer S.A.: Amendment 39-22834; Docket No. FAA-2024-1484; Project Identifier MCAI-2023-00968-A. (a) Effective Date This airworthiness directive (AD) is effective November 12, 2024. (b) Affected ADs None. (c) Applicability This AD applies to Embraer S.A. Model EMB-505 airplanes, certificated in any category, as identified in Agência Nacional de Aviação Civil (ANAC) AD 2023-07-01, effective August 10, 2023, as corrected by ANAC Airworthiness Directive Errata, effective August 10, 2023 (ANAC AD 2023-07-01). (d) Subject Joint Aircraft System Component (JASC) Code 2500, Cabin Equipment/Furnishings. (e) Unsafe Condition This AD was prompted by an analysis that the left-hand (LH) refreshment center and LH forward cabinet might not withstand the loads expected for specific emergency landing conditions. The FAA is issuing this AD to address the possibility of detachment of mass items during specific emergency landing conditions. The unsafe condition, if not addressed, could result in injuries to the airplane occupants. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Required Actions Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, ANAC AD 2023-07-01. (h) Exceptions to ANAC AD 2023-07-01 (1) Where ANAC AD 2023-07-01 refers to its effective date, this AD requires using the effective date of this AD. (2) Although the material referenced in ANAC AD 2023-07-01 allows the use of alternative or similar parts in place of the ones specified in the kits provided, this AD requires that alternative or similar parts be approved by the Manager, International Validation Branch, FAA; ANAC; or ANAC's authorized Designee. If approved by the ANAC Designee, the approval must include the Designee's authorized signature. (3) Where the material referenced in ANAC AD 2023-07-01 specifies to "discard" certain parts, for this AD replace that text with "remove from service." (4) This AD does not adopt paragraphs (c) and (d) of ANAC AD 2023-07-01. (i) No Reporting Requirement Although the material referenced in ANAC AD 2023-07-01 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (j) Alternative Methods of Compliance (AMOCs) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, mail it to the address identified in paragraph (k) of this AD or email to: AMOC@faa.gov. If mailing information, also submit information by email. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local Flight Standards District Office/certificate holding district office. (k) Additional Information For more information about this AD, contact Jim Rutherford, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (816) 329-4165; email: jim.rutherford@faa.gov. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this material as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Agência Nacional de Aviação Civil (ANAC) AD 2023-07-01, effective August 10, 2023, as corrected by ANAC Airworthiness Directive Errata, effective August 10, 2023. (ii) [Reserved] (3) For ANAC material identified in this AD, contact ANAC, Continuing Airworthiness Technical Branch (GTAC), Rua Doutor Orlando Feirabend Filho, 230-Centro Empresarial Aquarius-Torre B-Andares 14 a 18, Parque Residencial Aquarius, CEP 12.246-190-São José dos Campos-SP, Brazil; phone: 55 (12) 3203-6600; email: pac@anac.gov.br; website: anac.gov.br/en/. You may find this material on the ANAC website at sistemas.anac.gov.br/certificacao/DA/DAE.asp. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 901 Locust, Kansas City, MO 64106. For information on the availability of this material at the FAA, call (817) 222-5110. (5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov . Issued on October 3, 2024. Steven W. Thompson, Acting Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2024-23248 Filed 10-7-24; 8:45 am]BILLING CODE 4910-13-P