1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2023-14-02 Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership; Bombardier, Inc.): Amendment 39-22502; Docket No. FAA-2023-1408; Project Identifier MCAI-2023-00791-T. (a) Effective Date This airworthiness directive (AD) is effective July 27, 2023. (b) Affected ADs None. (c) Applicability This AD applies to all Airbus Canada Limited Partnership (Type Certificate previously held by C Series Aircraft Limited Partnership; Bombardier, Inc.) Model BD-500-1A10 and BD-500-1A11 airplanes, certificated in any category. (d) Subject Air Transport Association (ATA) of America Code 34, Navigation. (e) Reason This AD was prompted by a determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G C-Band), and a recent determination that this interference may affect other airplane systems using radio altimeter data, including the ground spoiler deployment system. The FAA is issuing this AD to address inadvertent ground spoiler deployment in flight that could lead to increased flightcrew workload and loss of continued safe flight and landing. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Definitions (1) For purposes of this AD, a "5G C-Band mitigated airport" (5G CMA) is an airport at which the telecommunications companies have agreed to voluntarily limit their 5G deployment at the request of the FAA, as identified by an FAA Domestic Notice. (2) For purposes of this AD, a "radio altimeter tolerant airplane" is one for which the radio altimeter, as installed, demonstrates the tolerances specified in paragraphs (g)(2)(i) and (ii) of this AD, using a method approved by the FAA. (i) Tolerance to radio altimeter interference, for the fundamental emissions (3.7-3.98 GHz), at or above the power spectral density (PSD) curve threshold specified in figure 1 to paragraph (g)(2)(i) of this AD. BILLING CODE 4910-13-P Figure 1 to Paragraph (g)(2)(i)-Fundamental Effective Isotropic PSD at Outside Interface of Aircraft Antenna ER12JY23.035 (ii) Tolerance to radio altimeter interference, for the spurious emissions (4.2-4.4 GHz), at or above the PSD curve threshold specified in figure 2 to paragraph (g)(2)(ii) of this AD. Figure 2 to Paragraph (g)(2)(ii)-Spurious Effective Isotropic PSD at Outside Interface of Aircraft Antenna ER12JY23.036 (3) For purposes of this AD, a "non-radio altimeter tolerant airplane" is one for which the radio altimeter, as installed, does not demonstrate the tolerances specified in paragraphs (g)(2)(i) and (ii) of this AD. (h) Revision of Existing Airplane Flight Manual (AFM): Master Minimum Equipment List (MMEL) Restriction for Non-Radio Altimeter Tolerant Airplanes Before further flight, revise the Limitations section of the existing AFM to include the information specified in figure 3 to paragraph (h) of this AD. This may be done by inserting a copy of figure 3 to paragraph (h) of this AD into the existing AFM. Figure 3 to Paragraph (h)-MMEL Restriction for Non-Radio Altimeter Tolerant Airplanes ER12JY23.037 (i) Revision of Existing AFM: MMEL Restriction for Radio Altimeter Tolerant Airplanes Before further flight, revise the Limitations section of the existing AFM to include the information specified in figure 4 to paragraph (i) of this AD. This may be done by inserting a copy of figure 4 to paragraph (i) of this AD into the existing AFM. Figure 4 to Paragraph (i)-MMEL Restriction for Radio Altimeter Tolerant Airplanes ER12JY23.038 (j) Additional AD Provisions (1) The Manager, Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Operational Safety Branch, send it to the attention of the person identified in paragraph (k)(2) of this AD. Information may be emailed to:
[email protected] . (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (k) Additional Information (1) Refer to Transport Canada AD CF-2023-47, dated June 26, 2023, for related information. This Transport Canada AD may be found in the AD docket at regulations.gov under Docket No. FAA-2023-1408. (2) For more information about this AD, contact Brett Portwood, Continued Operational Safety Technical Advisor, COS Program Management Section, Operational Safety Branch, FAA, 3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 817-222-5390; email:
[email protected] . (l) Material Incorporated by Reference None. Issued on July 3, 2023. Michael Linegang, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-14771 Filed 7-7-23; 4:15 pm]BILLING CODE 4910-13-P