1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2023-05-09 Airbus Helicopters Deutschland GmbH (AHD): Amendment 39-22378; Docket No. FAA-2023-0430; Project Identifier MCAI-2022-01092-R. (a) Effective Date This airworthiness directive (AD) is effective March 31, 2023. (b) Affected ADs None. (c) Applicability This AD applies to Airbus Helicopters Deutschland GmbH (AHD) Model EC135P3 and EC135T3 helicopters with Helionix installed, and Model MBB-BK 117 D-2 and MBB-BK 117 D-3 helicopters, certificated in any category. Note 1 to paragraph (c): Helicopters with an EC135P3H or EC135T3H designation are Model EC135P3 helicopters or Model EC135T3 helicopters with Helionix installed, respectively. (d) Subject Joint Aircraft System Component (JASC) Code: 3197, Instrument System Wiring. (e) Unsafe Condition This AD was prompted by reports of multiple multi-function display (MFD) failures during flight. The FAA is issuing this AD to address failure of an MFD and consequent loss of display information during flight. The unsafe condition, if not addressed, could result in the unexpected loss of display of important flight parameters to the pilots, which could result in loss of control of the helicopter. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements (1) Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, paragraphs (1), (2), (4), and (5) of European Union Aviation Safety Agency (EASA) AD 2022-0168, dated August 12, 2022 (EASA AD 2022-0168). (2) Within 7 days after the effective date of this AD, revise the existing Rotorcraft Flight Manual (RFM) for your helicopter by incorporating the RFM emergency procedure in Figure 1 or Figure 2 to paragraph (g)(2) of this AD as applicable to your model helicopter. Revising the existing RFM for your helicopter by updating the emergency procedures section may be performed by the owner/operator (pilot) holding at least a private pilot certificate and must be entered into the aircraft records showing compliance with this AD in accordance with 14 CFR 43.9(a) and 91.417(a)(2)(v). The record must be maintained as required by 14 CFR 91.417, 121.380, or 135.439. BILLING CODE 4910-13-P ER16MR23.003 ER16MR23.004 Figure 1 to Paragraph (g)(2): RFM Emergency Procedure-Model MBB-BK117 Helicopters ER16MR23.005 ER16MR23.006 Figure 2 to Paragraph (g)(2): RFM Emergency Procedure-Model EC135 Helicopters BILLING CODE 4910-13-C (3) After the actions required by paragraph (g)(1) of this AD have been done, no alternative requirements (inspections) are allowed unless they are approved as specified in the provisions of the "Ref. Publications" section of EASA AD 2022-0168. (h) Exceptions to EASA AD 2022-0168 (1) Where EASA AD 2022-0168 requires compliance in terms of flight hours, this AD requires using hours time-in-service. (2) Where EASA AD 2022-0168 refers to July 15, 2022 (the effective date of EASA AD 2022-0143 dated July 8, 2022) or its effective date, this AD requires using the effective date of this AD. (3) Where paragraph (1) of EASA AD 2022-0168 specifies "accomplish a check in accordance with the maintenance mode test procedure, and in accordance with the operational mode test procedure, as defined in this AD" for this AD, replace that text with "accomplish an inspection in accordance with the maintenance mode test procedure, and in accordance with the operational mode test procedure, as defined in this AD." (4) Where paragraph (2) of EASA AD 2022-0168 specifies "if, during any check as required by paragraph (1) of this AD," replace that text with "if, during any inspection as required by paragraph (1) of this AD." (5) Where the service information referenced in EASA AD 2022-0168 permits certain actions to be performed by a pilot or equivalent with the correct training and accreditation, this AD requires those actions to be accomplished by persons authorized under 14 CFR 43.3. (6) Where paragraph (4) of EASA AD 2022-0168 specifies to "inform all flight crews and, thereafter, operate the helicopter accordingly," this AD does not require those actions. (7) Where the service information referenced in EASA AD 2022-0168 specifies "If the continuity test is not satisfactory, check and repair the associated wires;" for this AD, replace that text with "If the continuity test is not satisfactory, inspect and repair the associated wires." (8) Where the service information referenced in EASA AD 2022-0168 specifies-contacting Airbus Helicopters for a technical solution, this AD requires corrective action done in accordance with a method approved by the Manager, General Aviation & Rotorcraft Section, International Validation Branch, FAA; or EASA; or Airbus Helicopters Deutschland GmbH's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (i) Special Flight Permits Special flight permits are prohibited for flights in Instrument Meteorological Conditions (IMC) and Night Visual Meteorological Conditions (VMC). (j) Alternative Methods of Compliance (AMOCs) (1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to:
[email protected]. (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. (k) Related Information For more information about this AD, contact Kristi Bradley, Program Manager, COS Program Management Section, Operational Safety Branch, Compliance & Airworthiness Division, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone (817) 222-5110; email
[email protected]. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2022-0168, dated August 12, 2022. (ii) [Reserved] (3) For EASA AD 2022-0168, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email
[email protected]; internet easa.europa.eu. You may find the EASA material on the EASA website at ad.easa.europa.eu. (4) You may view this service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on March 10, 2023. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-05426 Filed 3-14-23; 8:45 am]BILLING CODE 4910-13-P