1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2022-27-06 Embraer S.A.: Amendment 39-22291; Docket No. FAA-2022-1246; Project Identifier MCAI-2022-00675-T. (a) Effective Date This airworthiness directive (AD) is effective February 16, 2023. (b) Affected ADs This AD affects AD 2020-05-21, Amendment 39-19871 (85 FR 15940, March 20, 2022) (AD 2020-05-21). (c) Applicability This AD applies to Embraer S.A. (Type Certificate previously held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Model ERJ 190-100 STD, -100 LR, -100 ECJ, -100 IGW, -200 STD, -200 LR, and -200 IGW airplanes, certificated in any category, as identified in Agência Nacional de Aviação Civil (ANAC) AD 2022-05-04, effective May 25, 2022 (ANAC AD 2022-05-04). (d) Subject Air Transport Association (ATA) of America Code 31, Instruments. (e) Unsafe Condition This AD was prompted by a report of uncommanded setting of the barometric reference in both primary flight displays due to the architecture of data communication of the Control I/O modules, which interconnect the display controllers to the air data system. The FAA is issuing this AD to address this condition, which could interfere with the decisions taken by the flightcrew during critical phases of flight, and possibly result in reduced controllability of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, ANAC AD 2022-05-04. (h) Exceptions to ANAC AD 2022-05-04 (1) Where ANAC AD 2022-05-04 refers to its effective date, this AD requires using the effective date of this AD. (2) The "Alternative methods of compliance (AMOC)" section of ANAC AD 2022-05-04 does not apply to this AD. (3) Where paragraph (d) of ANAC AD 2022-05-04 states, "You must use the following service information for the installation of the Primus EPIC software versions 25.9, 27.4 and 27.4.0.1 as required by this AD," replace that text with "You must use the following service information for the installation of the Primus EPIC software versions 25.9, 27.4 and 27.4.0.1, as applicable, except as provided in paragraphs (a)(1) through (6) of ANAC AD 2022-05-04." (i) Terminating Action for AD 2020-05-21 Accomplishing the actions required by this AD on an airplane terminates all requirements of AD 2020-05-21 for that airplane only. (j) No Reporting Requirement Although the service information referenced in ANAC AD 2022-05-04 specifies to submit certain information to the manufacturer, this AD does not include that requirement. (k) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (l) of this AD. Information may be emailed to:
[email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or ANAC; or ANAC's authorized Designee. If approved by the ANAC Designee, the approval must include the Designee's authorized signature. (l) Additional Information For more information about this AD, contact Hassan Ibrahim, Aerospace Engineer, Large Aircraft Section, FAA, International Validation Branch, 2200 South 216th St., Des Moines, WA 98198; telephone 206-231-3653; email
[email protected] . (m) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Agência Nacional de Aviação Civil (ANAC) AD 2022-05-04, effective May 25, 2022. (ii) [Reserved] (3) For ANAC AD 2022-05-04, contact ANAC, Aeronautical Products Certification Branch (GGCP), Rua Dr. Orlando Feirabend Filho, 230-Centro Empresarial Aquarius-Torre B-Andares 14 a 18, Parque Residencial Aquarius, CEP 12.246-190-São José dos Campos-SP, Brazil; telephone 55 (12) 3203-6600; email
[email protected]; website anac.gov.br/en/. You may find this ANAC AD on the ANAC website at sistemas.anac.gov.br/certificacao/DA/DAE.asp. (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on December 21, 2022. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-00124 Filed 1-11-23; 8:45 am]BILLING CODE 4910-13-P